Search results

  1. H

    where does this grommet go?

    Re: where does this grommet go? it's boatsdotnet that i have been using any iboats keeps sensoring out but ya know i couldn't find parts breakdowns on thier site..... the grommet/seal is flat on one side and tappered on the other.i think it either goes into the top of the mid section or the...
  2. H

    where does this grommet go?

    HI guys. I got a 97 40 hp with a jet unit. had my lower engine cover off and noticed this grommet between the drive shaft and mid section. pulled it out and it's a tappered grommet but i'm not positive where it goes? i think i found it on this parts break down (...
  3. H

    bigger jets?

    HI guys. i have a 97 e40reuc. I just recently installed a set of chris carson reeds, and rebuilt 50 hp carbs. the motor runs but after it's warm i'm getting a sneeze back through the intake at idle and it will only open up to full throttle if i press the primmer switch while at full throttle...
  4. H

    power trim fitment

    Hello Fellas. this isn't exactly a mechanical issue but i'm looking for some help. i have a 1997 e40reuc. it came with just trim assist. I"m looking to fit it with power. now my issue i found a 92 3 cylinder 60hp motor found that has dropped a piston. i'm wondering if there is any way to make it...
  5. H

    97 evinrude after i overheated

    My motor over heated after i had sucked some leaves and gunk up in the jet unit and they got lodged in the thermo. i replaced my water pump and cleaned out the thermo. it pumps water good but now i'm noticing a little water drip out around the head gasket and at idle a mist of water is coming...
  6. H

    1997 40 HP theromstat removal

    Can I remove my thermostat and leave it out? Will it hurt any thing?
  7. H

    1996 40 hp evinrude. tilt assist not helping much

    Hi guys. this is my first post. I just recently purchase this boat and motor. When i first got it the assist was working on but i had to leave the motor off the boat for a few weeks to get some transom work done.... now my assist is more of just a lock for where you want the motor to sit. it...
Top