Search results

  1. S

    92 SeaDoo GTS handlebar wiring

    Thx
  2. S

    15 pitch prop on a 1988 force 50HP?

    Think it would be OK to use a 15 pitch prop on this 16' aluminum bass boat? Original was 12 pitch. Thanks!
  3. S

    1988 Force 50HP running good except at initial throttle

    I have my boat running well now... only issue that I have encountered is at initial takeoff (hot or cold same). It idles smooth and everything but when I drop into gear it wants to die before I can get it going. I have new plugs which may have helped a little but still a problem. Any advice...
  4. S

    1988 Force 50 HP flywheel torque spec?

    Can anyone tell me what I should torque 1988 50HP flywheel too? Thanks!
  5. S

    1988 Force 50HP cranking with only one CD coil pack OK?

    Re: 1988 Force 50HP cranking with only one CD coil pack OK? Thanks Jiggz I appreciate your help on this. I am attaching the installation sheet from CDI for the after market stator that I have so you can check if I am understanding the hookup correctly. Also.... I want to make sure you read my...
  6. S

    1988 Force 50HP cranking with only one CD coil pack OK?

    OK, I know I have one bad coil pack since it is melted on the back, wires burned, etc. I would like to test the other components with the single coil pack that I have which appears to be good, one cylinder at a time. Install on one cylinder and crank and then switch to the other cylinder. My...
  7. S

    Odd electrical problem on 1988 Force 50 HP- need expert help!

    Just recently purchased a used boat (1988 Fisher Marsh Hawk, 16'). Has a known engine problem that I felt I could repair. At the start of troubleshooting discovered two trigger wires reversed based on wiring documentation found online. (later read that these are sometimes reversed OK). Switched...
Top