Search results

  1. R

    cooling on Johnson 1979 150hp

    the motor does not seem to run too hot (157 degrees with a digital thermometer ) and the pee water is strong...but no water comes out the two holes on the leg of the motor..I also have a 1978 175hp that has a good stream coming out of these two holes ...not hot but runs at a max of 130...
  2. R

    Johnson 150 fuel pump

    I have a 1979 Johnson 150 with a fuel pump problem..it acts like it is running out of fuel ,,,I removed the fuel pumps and replaced the valves and gaskets including the diaphragm but all looked good...and still having a problem I also have a 1978 Johnson 175 that looks identical to the 150. The...
  3. R

    timing advance linkage

    I have a 1979 Johnson motor 175 hp that has a broken timing advance linkage...it is a short rod with plastic balls at each end...where can I purchase one of these? I cannot find this part and I am uncertain what the part is named or what the part # is...thank you Robert
  4. R

    compression on 79 Johnson 150hp

    I have a 1979 150hp Johnson motor that seems to start and run well on a stand BUT it only has 90# of compression on each cylinder...Is that too LOW??? also this motor seems to run smooth and accelerates quickly but will die and then not start again until it seems to cool down then it will start...
  5. R

    1984 Black MAX 150 HP

    can anyone tell me if a 1987 Xr2 150 hp outboard lower unit will fit a 1984 black max motor? I think this is is 2.0 litre engine but am not sure. I am in need of a lower unit for my 1984 motor and have found a "good" 1987 lower unit for $300.00 on craigslist. thank you much Robert
  6. R

    mercury lower unit

    I have a 1984 Mercury outboard motor that has most of the skeg broken off and the gears inside the lower unit are exposed . It still shifts and it will still run but will not hold oil in lower unit..(it is a very large hole ). I have been looking for a replacement lower unit but they are very...
  7. R

    carburatpr kit parts

    I ordered a carb kit for my 1976 105 Chrysler with tillison wb24 carbs and a small brass washer about the 1/8 inch across and a small rubber "o" ring came with the kit..I tried to install these in the air adj screw assembly but they will not fit there..Where do these parts go? also the kit...
  8. R

    chrysler carbs

    what is the difference in a WB24A and a WB24B carburater? I have a parts motor for a 105 Chrysler and the carbs have different numbers although the look the same. Will these carbs interchange and which will preform better? I am having a problem with the carbs on the running motor and wanted to...
Top