Search results

  1. V

    paint colors

    eye candy
  2. V

    1960 2hp west bend lower unit lube

    what do i do to keep the lower unit in gear oil, can't see where to put in, thanks dave i see a plug just below the prop but that is it, it's also smaller than the standard plug, i am missing this plug so if anyone has id be interested in purchase part#19109 gear housing plug, thanks
  3. V

    neutral/drive 1953 gale 5hp

    can get the shift in and out of drive working properly after i took off lower unit to replace impeller, wonder if i broke a tab or something putting back together. when you put into neutral the lever compresses the spring but the clutch lever has nothing to come in contact with, thanks dave
  4. V

    paint colors

    posted over there also
  5. V

    paint colors

    Hi all, i have a 1953 hiawatha 5hp, dark blue and silver, can someone come close on these colors, wanna be as close to accurate as possible dave
  6. V

    pontoon gas can tray for back pontoon

    just picked up from a steel yard an aluminum gas can tray that mounts on rear pontoon, at this time i am using gorilla 2 sided weather proof tape to install, however what about a couple self tapping pole barn steel screws going right into the pontoons, is this ok? dave
  7. V

    pontoon captains seat

    is there a standard distance from the console to the seat? getting ready to mount my captains chair thanks dave
  8. V

    1981 evinrude 2 stroke

    i have an evinrude 35hp #E35ELCIG, it has a 30hp evinrude motor cover on it, i want to paint and redecal to 35hp, the motor cover must be identical size correct? i'd like to buy the 35hp decal kit, just want to make sure they will fit on a cowl that shows 30hp dave gowen mi
  9. V

    pontoon cleats

    restoring my old harris, the cleats on the 4 corners are one large bolt out of the bottom, i want to replace them but don't know where to get them
  10. V

    1981 evinrude 35 hp, starts, runs great, won't shut off

    just installed a new switch, black/yellow to raised M, black to M, red to B, yellow/red to S, purple to C, not using A at this time, all 5 wires going to big connector on motor, with switch on off position i can kill the motor by clipping wire onto ground on battery and touching black/yellow...
  11. V

    working on 81 evinrude 35hp, starter question

    starter not firing, solenoid has 4 post.... small wire to switch, small black to ground, heavy gauge to starter and heavy gauge to battery, shows 12.6 volts to solenoid on battery cable. shouldn't i be able to jump to test starter? pos. battery cable to small non-ground wire going to switch to...
  12. V

    evinrude 35hp 1981

    is fuel to oil mixture really 100/1? thanks dave
  13. V

    boat trailer rewire project

    rewired my boat trailer with a basic wiring harness 4 wire, tested and everything worked great, my tail lights have two wires plus ground, so i then ordered my side marker lights(one wire lights) to each brown wire on each side, now my brake lights don't work, any ideas? thanks dave
  14. V

    submersible wire connectors, any recommendations?

    submersible wire connectors, any recommendations? thanks again dave
  15. V

    boat trailer rewire project

    rewiring my boat trailer, have questions on the ground, my old lights had no ground wire, my new lights have the white ground wire, i want to ground the white wire from the connector on the tongue to the tonque, however can i ground the light wires to the trailer frame by the light or do i need...
  16. V

    compression for a 25hp 1975 evinrude?

    what is good compression for a 25hp 1975 evinrude? thanks dave
  17. V

    1975 25hp evinrude outboard, starts but quits

    just starting with this motor, starts but dies when put into gear, and sometimes dies running in idle after 15 seconds, put an inline fuel filter before entering motor, what are the thoughts of that? squirted fuel mix in carb just before dying and does not help it to revive, what would you all...
  18. V

    70hp evinrude vro

    looking at buying this motor on an older pontoon, what is the range of years this motor was made? what is the proper compression of each of the three cylinders and would this be the best check to see if this motor was in good shape to restore? thanks dave gowen mi
  19. V

    1971 25hp evinrude, shearing of key problem

    just put a new tune up kit on this motor, runs great for a good while(half a day) then it quit on me, took it apart and found the key was sheared off, so found another one from my pile of older evinrudes and replaced it, ran great again for a half a day then it quite again, checked the key again...
  20. V

    remote wiring harness for 1971 evinrude 25hp

    i have found out that the connector from the boat side harness is defective(part#385158), the motor side of this connector is fine(part#385157), i have no problems building my own harness however i would like to leave the motor harness in the motor and connect to it in a different way, how would...
Top