Search results

  1. D

    J30RLCOA 1985 3 stator wires and bridge rectifier configuration question

    I have a J30RLCOA 1985 and have just converted it to an electric start - starts immediately and runs OK - now I need to add a charging circuit - there are three wires coming from the stator and I have not yet put a meter on them when she is running - I have a bridge rectifier capable of...
  2. D

    engine BJ30BALCO = J30RLCOA 1985

    the pest again I'm afraid I have an engine BJ30BALCO which is according to you good folks = J30RLCOA 1985 now I have purchased a starter motor for it giving them the engine number BJ30BALCO but there does not appear to be any room available to fit it in - the seller has re-checked and the motor...
  3. D

    Lowrance GlobalNav 11a (2a ?) GPS

    I have one of these without any cables at all - does anyone out there have the ones I need they can sell me - or anyone give me the part numbers for the original leads or equivalents - I have a Garmin Antenna (co-axle cable) can I use this if I get the correct plug - can anyone tell me the pin...
  4. D

    new boat and engine - Shetland 535 & Johnson 30 HP twin stroke outboard -

    everything in my favor is going against me I have been through the lists looking for my engine - a Johnson two stroke numbered BJ30BALCO The closest I can find to the number is 1998 BJ30BALECS can anyone help me out here please as need a starter motor fitting - I believe there is a place to...
  5. D

    johnson 0334050 carb cover - 9.9HP two stroke 1988 J10SELCCD

    looking for the following carb bits - a crap repair on the carb cover of my engine needs replacing - the carb lid has been repaired with car body filler - the cam follower area of the carb cover had been broken off - so I am looking for the cover and cam follower assembly - If anyone has one...
  6. D

    Johnson 9.9 two stroke J10BALCSF or perhaps J10BA1CSF

    Hi at 62years old I am new to this boating fun - I have the above engine that has an approximate five inch piece just above the prop area - would it be possible to change this engine from a long to a short shaft by removing this piece and shortening the shaft ?? this engine goes really well and...
Top