Search results

  1. U

    I/O 18 ft. Does it sit too low in the stern?

    Which video is it? I looked at several. We are figuring out how to handle the outdrive with what we have. Probably will need to rig a stand to set it on.
  2. U

    I/O 18 ft. Does it sit too low in the stern?

    Took it back to the lake. No leak from speedometer so continued to lower into lake. Water poured in from bottom of transom seal. So... is this something we can do ourselves....
  3. U

    I/O 18 ft. Does it sit too low in the stern?

    Took off the speedometer. Put a hose to the holes. Water poured in at the same spot as it did when we took it to the lake. Removed, glued and rescrewed speedometer. Will test with hose and lake. Hoping this will be the answer. Thank you for your responses.
  4. U

    I/O 18 ft. Does it sit too low in the stern?

    The water appeared to be streaming from the right side of that metal piece below the transom seal.
  5. U

    I/O 18 ft. Does it sit too low in the stern?

    Took the boat back to the lake and backed the trailer in until we had a leak. The leak is coming out the end of a straight metal piece with screws mounted to the stern , left of the motor. It is very gummy/black on the end of the piece closest to the motor.
  6. U

    I/O 18 ft. Does it sit too low in the stern?

    Added water to inside of boat hull up almost to the plywood floor. 3 drip spots at about 1 drip/30-60 seconds. could that have caused 6" of water on the floor of the boat in an hour in the water?
  7. U

    I/O 18 ft. Does it sit too low in the stern?

    Could see the water going through the pump hose
  8. U

    I/O 18 ft. Does it sit too low in the stern?

    Tried muffs to see if leaks. Nothing inside. Is water supposed to spray out like this?
  9. U

    I/O 18 ft. Does it sit too low in the stern?

    OMC 400 series, 140hp. If the leak is in the drive or water pump, would it be noticeable if we ran it with the earmuffs?
  10. U

    I/O 18 ft. Does it sit too low in the stern?

    OK, will go to the weigh station. We bought the boat on FB. First time out the boat took on water. We needed to run the pump util we got back to the trailer. The man seemed honest, I hate to think of him selling us a leaking boat on purpose but 1st time out it took on a lot of water. The...
  11. U

    I/O 18 ft. Does it sit too low in the stern?

    Thank you! How much of the motor should be submerged?
  12. U

    I/O 18 ft. Does it sit too low in the stern?

    Sylvan 18'. New to us. First time in water. Is it OK?
  13. U

    draft and tilt trailer

    How much draft will a 1979 18' sylvan sportster need? It has a Cox tilt trailer, same vintage. We took it for the first outing yesterday at our village ramp and only the back of the boat reached the water. We didn't feel confident launching. The water was 27" where the back of the boat was...
  14. U

    New Tohatsu 6C needs 5 or more pulls cold or warm

    Followed the instructions for break in Fooled with choke and throttle settings Our old Evinrude 2 stroke started more reliably Any ideas?
Top