Search results

  1. B

    2002 90bf starved or excessive fuel???

    I recently bought a used honda 90hp 4 stroke. It only had 40 hours on it. It now has 63. Sometimes, not always, the engine will only get up to 2000 rpm before stumbling. I can run it that way and it seems ok (except for the lack of rpm). I pull the throttle back and it idles fine. If I turn it...
  2. B

    70hp Force surges at WOT

    '92 70 HP FORCE surges slightly at WOT and only at WOT.<br />Starts right up and will run all day. Even runs all day at WOT but surges.<br />I just put new tanks and gas lines and bulbs on boat. HELP!!
  3. B

    tilt o-rings '88 force 125

    hi. i can't remember if an oring goes in the inside groove on the trim/tilt pump. i've had it apart all winter. take a look where i mean you can see it here valve
  4. B

    screws for cables

    hi.<br />i would like to know what size the screws are that hold the control cables to the block. i have a '88 125 force. the cables run thru a holder and i misplaced the screws that hold the holder over the cable.<br />thanks!
  5. B

    cable screws 125 force

    hi. <br />does anyone know what size the screws are that hold down the throttle and gear shift cable retainer on the block of a '88 125 force???
  6. B

    88 125 Force trim valve

    I wasn't thinking when i was tapping the trim valves out. i forgot to remove the shuttle valve. it is now bent. does anyone have one they want to part with. please let me know.<br />thanks! <br />i took a picture of it shutter valve <br />i thought maybe i could still use it if you think its not...
  7. B

    1989 125hp FORCE tilt trim

    does anyone have a trim/tilt pump that they would like to sell. i tried to rebuild mine with new o-rings and used 30wt oil and it still bleeds down. i give up.
  8. B

    125 force trim/tilt pump HELP!!

    I've rebuilt the pump unit. It works, but still wants to bleed down about 1/2 way. I've replaced the o-rings. The bore was not scored. It works fine to go up and down. Do I need to cycle it thru a few times as i've cycled it about 6x.<br />I used 30wt motor oil. It is a 1989 125hp.<br />HELP!!!
  9. B

    1988 - 125 force - tilt pump

    i took the tilt trim pump apart and i can't get the ends where the snap rings are, out. any suggestions on how to get the end caps off?
Top