Search results

  1. L

    Tacho running backwards??

    HI Guys. I have just replaced a faulty rectifier on my J60TLCIH. wiring all same as diagram but my tacho seems to be running backwards. also motor doesnt seem to be charging?? any help would be greatly apprecieated. cheers guys!!
  2. L

    Fuel pump help?

    Hi guys. I have pulled apart my Fuel pump to replace gaskets etc. (J60TLCIH) Just wondering if anyone can help with a diagram of what gaskets go where? (internally). The motor runs ok but seems to lack fuel under load. I suspect i may have done something wrong? any help would be appreciated...
  3. L

    Motor wont charge and tacho not working with new stator....Help....

    Hi guys. i have just replaced the stator in my J60TLCIH 60hp jonno. the old stator was almost split in half so i got a nother one from my local wreckers. was assured it was in working condition. engine runs fine so i assume its ok...But when the engine is running its not charging. battery only...
  4. L

    Link and sync help please...

    Hey guys! Could anyone please help me with link and sync precedures for a 1981 johno 60hp 2 cyl? (J60TLCIH). Im stuck and dont have access to a repair manual.....:mad: im desparate to get back out on the water!! thanks heaps guys! :)
  5. L

    Help with testing Coils....

    Hi Guys!! Im hoping someone here may be able to shed some light on how to properly test a coil..... I have a 60 HP johnson 2 cyl (J60TLCIH) that i suspect has a coil breaking down under load.. IM not exactly sure how to test it properly and isolate the fault. I dont want to go and buy new...
  6. L

    floods on start up and wont rev past about 2500 on water....

    Hey Guys.. Im in need of some advice. I have a J60TLCIH 60hp jonno 2 cyl. I have just done a complete rebuild on it. pistons, rings, bearings, carbs the works. I have run it on the muffs, seems to start ok, and run ok. but when i put it in the water it is hell hard to start. pull plugs and...
  7. L

    1981 60hp powerhead removal??

    Hey guys, firstly im new to the forum and would like to say HI. I have just removed the powerhead off my 81 J60TLCIH motor. powerhead came off fine, but in the process i have damaged the gasket on the adaptor plate that stays on the lower unit, thinking it came off with the powerhead i was...
Top