Search results

  1. F

    Quicksilver control.

    I have a 95' Bayliner, and the throttle control is not making contact for the kill switch. Neither is the trim and tilt switch, which is somewhat sporadic. Can I open the housing to gain entry and is there a trick? What does a whole new unit cost and are they difficult to change? Thanks, Dave
  2. F

    Kill Switch

    Hi, I've got a Force 120 with Merc controls and it always fired up then it wouldn't turn over even with a full battery and charger with start mode. I think it's the contact in the switch. Is there anything else I should look at or test? It's had a lot of use, it's a 1995 system, Thank You...
  3. F

    2hp starting

    I have an early 80's Johnson 2hp. I can't remember how to start it with all the knobs on the front. It's 100/1 fuel. Can someone post a pic. of the front and tell me what to use. It has two knobs. And a small switch on the left side, real small.Thx, Dave
  4. F

    Bayliner Dash

    Hi everyone, I have a 95' SF 1704 with the 120 one it. The dash is faded. Does anyone know what the rocker switch seqence is from the left to the right? there are six and I know that the first one is the horn. The dealer where the boat was purchased and the Bayliner people who built the...
  5. F

    The Fried Force

    Hi, everyone. I have a 1995 120 force. I friend that knows engines tested the comp. and it was 120, 80, 150 ,150 and it has been blowing water out of the exaust. I thought that was normal. After it warms up it will push a stream out of the p hole. It always ran well and least I thought so...
  6. F

    Force 120 at idle

    Hi guys, This year I've used the boat twice and both times when reducing the speed to idle the engine dies. Even launching and trying to back out form the dock it will die each and every time. Does anybody know it this is a fuel filter problem or something else.. I have four cylinders and...
Top