Search results

  1. S

    94 200 still runs rich

    My 94 200 still runs rich at low rpms and loads up, but does not die. My hole shots take a few seconds to get going after the engine finally clears out from loading up.<br />I have:<br />replaced bad thermostats (one stuck open)<br />checked compression--all good<br />checked for leaking or high...
  2. S

    Am I missing something????

    After finding bad recirculation system check valves in my 94 TXERK 200hp Evinrude, I thought that all my problems have been solved.<br />I have:<br />replaced bad thermostats<br />checked compression--all good<br />reset all floats to correct level<br />synched/linked<br />replaced one bad...
  3. S

    Bad recirc valve symptoms?

    I am slowly whittling away at my 94 200TXERK Evinrude's running issues. My manual states to start at 2-1/2 turns on the air bleed screws. My engine seems to run best at the max recommend adjustment from 2-1/2, which is 4-3/4 to 5 turns out. It still seems to be running rich up to about 2500...
  4. S

    Electric shock from trim switch

    My 94 200 Evinrude shocked me pretty good the other day. Both hands were wet, one on the stainless steering wheel, and the other on the throttle. I was starting to slow down and trimmed the motor down, only to be zapped from my hand on the throttle, through my shoulders and down the other arm...
  5. S

    2003 225 Ficht water pressure tap fitting

    I just picked up a boat with a 2003 225 Ficht Evinrude on it. The boat has a water pressure gauge on the panel, but whoever rigged the motor did not connect the hose at the motor. It is just lying inside the motor cover. Can anyone tell me where the fitting for the hose normally screws into on...
  6. S

    3000-3500 engine stumbling

    94 Evinrude 200 OceanPro acts like the low speed jets in one or more carbs have trash in them.--Pulled carbs for a quick look tonight. Nothing obvious stood out, other than the floats looked high on a couple of carbs.The engine seems rich at lower RPMs, but seems lean around 3 to 3500<br /> It...
  7. S

    94 evinrude 200 bypass blew off

    My 94 200 blew the port side bypass hose fitting on the thermostat housing. I did not know this until after I limped home today and checked it in the driveway. The engine was running very poorly, with a lot of gas dripping out of the exhaust when I pulled it onto the trailer at the ramp. No...
  8. S

    Yamaha 25 mid range miss

    My 1990 Yamaha 25ESD has a miss from 1/2 to 3/4 throttle. It runs fine wide open and on hard accel from a stop. I have been through the carbs 2 times, thinking I may have overlooked something the first time. I have tried a new CDI module, new trigger coils. It still feels like it wants to surge...
Top