Search results

  1. C

    Compression Numbers - 1986 Evinrude 110 HP

    Sounds good and reasonable. I have the OMC Service Manual. I'll pull the head off and post some pics. Maybe I'll get lucky and it's just the head gasket. More to come. Thanks.
  2. C

    Compression Numbers - 1986 Evinrude 110 HP

    Is it easy for a backyard mechanic to replace the rings? I've got the manuals. I'm guessing if the rings are broken they could have done other damage?
  3. C

    Compression Numbers - 1986 Evinrude 110 HP

    Left side top - 100 Left side bottom - 95 Right side top - 115 Right side bottom - 115 Motor has been sitting up for a number of years. Compression test done with throttle wide open but motor is cold because I didn't want it to start. I'm determining whether to spend the money to take it to a...
  4. C

    Starcraft 60s era Holiday bare bones weight

    Thanks! Everything was removed from the boat when I got it. Except the transom and the floor which were both really just wood pulp. No model number plate anymore.
  5. C

    Starcraft 60s era Holiday bare bones weight

    Good day! I have a 1960s era Starcraft. It's 18' +/- an inch or two. Appears to be a Holiday but can't verify because it's pre-hull ID and the plate is long gone. I'm in the process of replacing the floor and transom. This will be a fishing boat. The 1967 Starcraft Brochure lists the weight of...
  6. C

    1997 Evinrude 50 HP Idle Question

    A little history. I've replaced the power pack, coil, rectifier, starter solenoid, cleaned and rebuilt the carbs (believe me they are clean as a whistle), replaced all of the gas with non-ethanol gas w/marine stabile, replaced the spark plugs and wires, and a few other odds and ends. This...
  7. C

    1997 Evinrude 50 HP on Aluminum Boat

    After reading much information here about the importance of not grounding electrical equipment to an aluminum boat I've now removed all grounds from the boat and put them on a home run to the battery with a grounding block out to each unit. Some background the engine is model# E50TLEUC. The...
  8. C

    Starcraft Identification

    I have a Starcraft Runabout that predates the HIN. The dimensions - best I can gather them due to impediments are: Center Length - 15' 7" Gunwale - 16' 1/4" Beam 70" Transom width 64' 1/2" Transom depth 21" This boat has been made into a fishing boat and only resembles it's former runabout...
Top