Search results

  1. M

    Impact wrench on flywheel nut?

    Hello, is using an impact wrench to remove the flywheel nut ok?
  2. M

    battery cables reversed

    Hello,<br />I have a 96 Johnson 90 hp. The battery cables were accidentally, reversed, and quickly <br />corrected. Apparently not quickly enough as now the charging system does not seem <br />to be working. What have I damaged?<br />Thanks
  3. M

    90hp Johnson TL, TX, ML?

    Hello, What features do the TL, TX, and ML designations represent, on a 1996 90 hp. Thanks
  4. M

    prop advice

    I have a 1997 18' aluminum Seaark ZX180 with a 90hp 90 degree Johnson. At full throttle it runs 44 mph @ 4600 rpm. It is proped with an OMC SST 13 7/8 x 19. I have been told it should run at 5200 rpm. What prop diameter and pitch should I use?
  5. M

    hydrofoil

    hydrofoil Will the use of a hydrofoil on my outboard overstress the cavitation plate?
  6. M

    trim gage adjustment

    How do I adjust the trim gauge on my 1996 90 degree johnson 90 hp? When engine is at its lowest position, the gauge needle is way below the marks. Thanks
  7. M

    No oil warning horn

    I have a 1996, 90 hp, 90 degree, Johnson outboard. I decided to run premix fuel and have disconnected the VRO system. The oil line has been disconnected, and plugged at the oil pump. The two leads from the VRO oil tank are disconnected at the engine. Occasionally while cruising, the "no oil"...
  8. M

    VRO fuel/oil pump

    I am the second owner of a low hour, 96 Johnson 90hp. Due to lack of trust, I would like to temporarily bypass the oil injection system, as the next owner may prefer this system. Will plugging the oil intake hose at the pump, and disconnecting the two sensor wires at the engine, cause permanent...
Top