Search results

  1. G

    extend trailer hitch

    i would like to extend my 2 inch reciever hitch<br />out about 18 inches to attach a bike rack will this be ok? i will need to drill 2 3/4 holes in the hitch to attach the mounting hardware<br />i will also be pulling a 19' alum boat with 70hp<br />outboard see any problems ??
  2. G

    charging batteries while driving

    read somewhere that you can buy a kit for<br />about 50 bucks that will allow you to charge<br />your trolling motor battery while driving.can i <br />do the same thing by running my own wires without<br />purchasing the kit.<br />is it as simple as running wires to boat battery<br />from your...
  3. G

    bearing size

    how do you know what size bearings to purchase<br />without taking them off first.I have a 19'<br />alum. boat on a ez loader with 14" tires.<br />no breaks.have bearing buddys on for 14 years<br />and never repacked them , but you guys are starting to scare me dont want to be the next<br />on...
  4. G

    carb bypass/check valve ???

    1986 70hp 3cylinder evinrude,manual said to check<br />the cylinder drain hose check valve.cant find it<br />on my motor unless its the hose that connects to<br />the air silencer at the bottom.if it is that <br />where is the check valve located,because you<br />can blow air and suck air from...
  5. G

    fuel line size evinrude 1986 70hp

    what size is the fuel lines feeding the carbs.<br />the marine shop only has omc part #'s<br />and not the actual size. i'am in the middle<br />of a rebuild and the hoses are old and need<br />replacing.
  6. G

    carb fuel line size 1986/70hp3cylinder

    Got a 1986 70hp 3cylinder evinrude,<br />Anyone know the correct size of the <br />fuel line that goes to the carbs?<br />Mine are 19 years old and need to be replaced<br />the marine shops only have part numbers<br />and not the ACTUAL size.also the electric primer hose size.Is the best way to...
  7. G

    carb. rebuild NEED HELP

    have 70 hp 3 cylinder 1988 evinrude<br />when rebuilding carbs do i need to<br />replace the flat disks ? what is behind them ?<br />any other words of advice would be helpfull<br />also how do i get them out and do they just<br />pop back in
  8. G

    tdc how to find

    i need to find top dead center book said to use<br />a dial indicator been to 3 auto parts stores<br />they have no clue what that is . is there somthing<br />else i can use ? is there a easy way to find tdc?<br />evinrude 1988 70hp 3cylinder
  9. G

    cabelas oil

    Has anyone used cabelas 2 cycle oil<br />good/ bad or indifferent.iam using<br />evinrude oil and not happy with the way<br />the motor runs.
  10. G

    cabelas oil

    Has anyone used cabelas 2 cycle oil<br />good/ bad or indifferent.iam using<br />evinrude oil and not happy with the way<br />the motor runs.
  11. G

    stalling

    i have a evinrude 1988 70hp 3cyl<br />stalls when i put it into gear starts good<br />runs very well any thing above idle will only<br />idle without stalling with a hi idle. it will<br />keep running in gear if i increase the gas but <br />that speed is to fast for trolling
Top