Search results

  1. R

    86’ 200GT Delete water control valves

    I’ve read fastbullets full write up, but I’m trying figure out exactly what part I need to order out of the 89 70hp Tstat setup that I need to order I’ve been a mechanic in a marine shop for 14 year. So I you know that parts just tell them to me, I know what to do I just want to order the right...
  2. R

    1982 Suzuki 140DT Need Electrical Specs

    hi guys Every manual I can find is 1983 and newer. This is a 1982 DT140 2stroke 4 cylinder. I am looking for the DVA and resistance specs for the stator and the switch box. There is nothing in the CDI trouble shooting guide, and all my manuals start at 89, I see some online starting in 83, but...
  3. R

    Mercury 40 HP Lower unit question for the Pro's

    This is a: MERCURY - ( 40 H.P. (1992 )) Serial No: 0D129270 Model No: 1040411MD Catalog No: 814698 That is right out of the Brunswick web app. Here's the Problem the lower unit is taking in water, It is taking on water on the muffs as well as taking in water while in a thrust tank...
  4. R

    95 AlphaOne 2nd gen powersteering/ steering adjustment???

    I am working on the attempting to fix some what of a steering issue. Here is my issue, I have a starboard side mounted steering system, and I can make a fairly sharp right and a very broad left when driving, so in other words the out drive turns further to the right than the left. Power steering...
  5. R

    Yamaha wave venture 1995 No Power

    My Yamaha wave venture 1995 has No Power, I pulled the battery and trickle charged it cause it was at 61% and thought that was my issue. Well now its fully charged and back in, power and ground cable are firmly screwed in and the ground cable at the block is tight too. The fuse in what appears...
  6. R

    1970's Johnson Sea horse Idle Question

    so this is a 1970's sea horse, its a 6hp, and It runs great works fine and all but the idle is just a little off. I work on boats for a side job but I have run into this situation before and been a little baffled. So what happens is that i have to turn the tiller arm throttle up a little to keep...
  7. R

    Cracked Block? It Has Good Compression

    Can anyone verify for me that this is a cracked block??? It has good compression, and will run but the water jacket gasket was bad :( the third picture is a shot looking up from as if the motor was mounted on a boat looking up from the ground.
  8. R

    1963 Evinrude lacks power at WOT

    So here's the situation, I did points, coils and condensers and week or two ago, and then took it out for a spin and she was real slow, so I brought it back to the garage and decided to do a compression check and came up with 95 psi on both cylinders, according to the specs it should be 100 psi...
  9. R

    1977 35hp Johnson wont turn off

    just like it says this has electric start, but when I turn the key to the off position it wont kill the engine. Any ideas??? thanx in advance....:mad::mad:
  10. R

    PCM 5.7 Excalibur knock sensor issue

    Heres the deal, we've got a 2005 ski natique, with a PCM 5.7, we replace the knock sensor about two weeks ago cause the old one kept tripping the code, the motor runs great, we run 91 octane non oxygenated gas, and it tripped the code again today. I have the diacom marine software and cable so I...
  11. R

    50 hp Spark on 1 and 3 but NO SPARK on 2 and 4

    :mad:This is a 50 hp 1982 merc, just replace trigger(had a bad black wire) and repaired yellow wires on stater due to bad wires. the coil packs and plug wires are good and tested and ohmed out, as well as I swapped with working wires to test. Stator ohm's out on around 8.00 on the 20k setting...
  12. R

    Pulling trigger assembly on 1982 50 hp Merc

    I pulled fly wheel and there is another pressed nor threaded lock on the cranck shaft, normaly the forces and johnsons I work on have the key between the flywheel and crank, but this key islocated between crank and some sort of coupler when I pull the schematics up this part does not show up...
  13. R

    Exhaust Manifold Torque Specs?

    2005 Correct Craft super air nautique exhaust manifold torque specs Chev 5.7 ltre Block PCM excalibur 330 Motor? If any one knows the specs that would be great thanks.
  14. R

    6 HP Nissan 4 Stroke

    This motor was having problems running after about ten minutes it would lose power. Removed and cleaned carb plenty of dirt inside. reinstalled carb now Low oil pressure light flickers when I yank the pull start and engine will not start. any ideas would be helpful. thanks
  15. R

    FlyWheel Nut Torque Spec 1994 50hp Force???

    FlyWheel Nut Torque Spec 1994 50hp Force??? Any one Know??? my Johnson 55hp is 105lb but i have no idea and cantfind it on line. Also thankyou to every one who has been a bighelp these last couple days!!!
  16. R

    50 hp NO SPARK ahhhh

    ok so I posted earlier and I could not figure out how to remove the thread cause I was way off so i started this one. So it turns out I have no spark on my 1994 force 50 hp. I ohm'd out the coil packs on the plug wire and came up with 902 on the top pack and 908 on the lower, there seems to...
  17. R

    1994 50HP Force Starting issues???

    So I havent been on here in a while but I have hit another speed bump, I picked up a force 50hp, and i have good gas thru the lines and in the carb, I have good spark at the plugs, good compression, and good coil packs, wiring is right, engine turns over but wont start. Any Ideas????
  18. R

    Johnson Prop part number question?

    Does any one know what exactly my motor was based on the prop part number I thought it was a 15hp. It's a 13 spline 9 x 10 and the casting number is 315084? I have included some picks i thought i might put this up for sale on craigslist but I had like a 4 little johnsons at one time and I...
  19. R

    Spun prop not so sure?

    Ok so the crank, engine, lower unit, all seem fine. But so does prop, that too seems ok. I haven't scored or marked the hub from the prop too see it it slips but, they can not be turned seperatly by hand. Is the slipping action of the prop, only replicated by high speed rpms of a moter, or...
  20. R

    Eska 3.5 HP Spark Plug ???

    ok I have a Eska 3.5 hp and Modle number 1703D, Iam not sure what year it is, but it has no spark plug but looks in great condition, does any one know what kind of plug it uses? thank you all you smart boat people.
Top