Search results

  1. P

    lifting 70hp Evinrude

    I need to lift my 1974 Evinride 70hp from the boat for transom repairs. There appears to be a lift ring on the engine block. Is this ring designed to hoist the entire engine or just the engine block.<br /><br />Advise appreciated
  2. P

    1984 & 1988 Evinrude 20 hp motor compatibility

    Can someone tell me if the 1984 & the 1988 Evinrude 20 hp motors are the same basic engine<br />whereby the parts, such as, carbs, manifolds, cylinder heads, etc are interchangeable? I had posted a question about a 1980 Johnson 35hp being compatible with a 1984 Evinrude and was told they were...
  3. P

    1981 Johnson 35hp and 1984 Evinrude 20 hp

    I'm trying to find out whether the 1981 Johnson 35 hp motor and the 1984 Evinrude 20 hp motor are the same basic engine. Are the carburetors and intake manifolds interchangeable between these motors or are they completely different motors?<br /><br />I have access to the 35 hp for parts and was...
  4. P

    spark gap tester

    Where can I order and purchase a spark gap tester for mid-80's OMC outboard ignition tests. <br /><br />Thanks, GeorgeN
  5. P

    Rough running 20 hp Evinrude

    I own a 1984 20hp manual start Evinrude. The motor was purchased on ebay and was a rough running motor from the start. I've had the complete fuel system redone carb rebuild, fuel pump replaced and all hoses replaced. The kill switch in the tiller had a high resistance short and we replaced it...
  6. P

    1988 Evinrude 20hp rough idle/low RPM

    My son just purchased a 1988 20 hp Evinrude on ebay advertisewd as in mint condition. The motor came and under the motor cover it looks to be in very clean condition. He took it out and ran it on the lake to find it had a yawl or hesitation when accelerating, but it ran good at top end.<br...
  7. P

    6hp Evinrude ID+lower unit probs

    I have a 6hp Evinrude the model number is 6904E. The engine has been on a motor stand in my garage for two years and I noticed oily sticky film on the lower unit housing and a spot on the floor that appears to be coming from the bottom end. It's the split case bottom end and I'm trying to...
  8. P

    Engine ID

    I have a 6hp Evinrude Model # 69D4E, Ser #<br />J00101170. I'm trying to find out the year so I can order gaskets and seals kit(s) for the lower end. I believe it is a mid-seventies motor, but I'm not sure. The motor cover is flat on the side that mates to the powerhead. Any help much is...
  9. P

    Problems with Honda 100 10 hp 4 stroke

    My reliable Honda 100 has developed an intermittent problem. It will occasionally not start and run unless the choke is pulled out.<br />The minute the choke is pushed in it dies.<br />Last time out we completely removed the metering adjustment from the carburator and put it back in to the...
Top