Search results

  1. F

    9Starting problems Bf 8 1987 frame with 10 hp powerhead

    Good day everyone. I came across an old Honda outboard, eight horsepower, and the power head was salt encrusted so much that water would not circulate. The specs on it were a BF8AHLA, frame id# BACL 1000542. Model year 1987. I removed the power head, and replaced it with a 10 horsepower head...
  2. F

    Honda 10 hp powerhead in Honda 8 hp frame ignition problem

    I "rescued" an 8 hp Honda outboard, pre 97. It had been submerged in salt water and left laying on the beach for who knows how long. I got it started and it overheated instantly. I turned it off immediately and tore into it. Discovered that salt had clogged all of the cooling passages. When I...
  3. F

    Volvo U-joint and shaft seized in motor

    Re: Volvo U-joint and shaft seized in motor This is what I made and used successfully on my 280 with the same problem. I removed the upper gear unit as far as I could, strapped the bellows and got it out of my way, then I hammered out the outermost ujoint bearings and "cross piece"and...
  4. F

    installing aq120 engine

    I need to know if there is any kind of lube or sealer that has to go on the 2 large "donut" rubber gaskets in and out of the transom when installing the engine ( cantilever mount-270-289):confused: Penta p/n 804190 nomenclater "rubber ring" Thanks in advance btw, My ujoints were stuck on the...
  5. F

    gale 1960 5hp shift rod

    I am trying to find a way to remove the lower case, the shift rod is preventing this. I need to rplace shaft seals after checking pump impellar (shaft seal parts at the motor end fell out during the check) Help!
Top