Search results

  1. 99z286spd

    Set timing without marks?? 3.0GS

    Is there a way to set timing without the marks on the timing cover? I have the required shunt and timing light but when I attempted to time the engine, there are no marks visible on the cover. Can I just set #1 to TDC? How will I know if I'm on compression or Exaust stroke? Thanks for any...
  2. 99z286spd

    New to me boat..1998 Volvo Penta 3.0 model info?.

    I want to get manuals for my engine and outdrive. Can someone refer me to where I can find the model info on my engine and drive? I believe it is a "by" but not sure. It has a bright red carburetor on it too... Is this an upgrade? Also any ideas as to how to fix a wobbling steering wheel...
  3. 99z286spd

    "0" reading at idle Any Ideas?

    I have a E88MSLESA It runs awesome but at idle my tach reads 0 or just above. At WOT I read 5400 which is what i tuned the engine for with the prop/trim. Idle though is nice and smooth and slow, but definitely not under 100 rpms. The rectifier is new(tested with MM before install), i checked...
  4. 99z286spd

    Lower unit E88MSELSA is leaking

    There was no fluid in the lower unit when i got the engine so i swapped the lower unit with my old engine's lower unit. I'd like to fix it myself. Could it be something as simple as a seal? It seams to be leaking from inside the hub area not from the shaft seal. Also, i took out the 4 bolts that...
  5. 99z286spd

    What MODEL Wellcraft do I have???

    Hi everyone, Ive been searching for pictures on the internet and such but nothing. I have been wondering what the model name of my "free" CL boat is. The HIN is WELR4208H586 It is a 17.7 ft boat Bowrider with outboard engine Walk through windshield Can anyone decode the HIN or give me a...
  6. 99z286spd

    How dumb of me....

    Im new here and i have been doing a LOT of reading and searching and finally sighned up. I aquired a wellcraft 17.7 bowrider boat through Craigslist 4 months ago for free! I was told it wouldnt run. I'm always up for projects so I went for it. It had a 90 hp e-rude 1982. I got it to run but not...
  7. 99z286spd

    powehead swap 83 90hp to 90 88 spl

    As stated I'd like to swap powerheads but in reading the seloc manual it is very vague on how to remove the powerhead from the outboard assembly. I have the tools and general knowledge I just need some pointers from someone who has done this before. The manual says to remove two bolts and two...
Top