Search results

  1. J

    no tell-tale when in gear

    ok, so i replaced my impeller due to no tell-tale water. when i got it apart, the impeller was definately in bad shape. a couple of cracked fins, and the rubber was hardened, but nothing had broken off. i put it in the tank this morning to test it, and it pees strong when idling and at higher...
  2. J

    tell-tale blockage

    i'm not getting any water out of my tell-tale so i am replacing my impeller. the fins were curved and a couple cracked, but all in 1 piece. i figured i would check and make sure i dont have any blockages in the water tube and read an earlier post about feeding trimmer line down the tube. i can...
  3. J

    splined drive shaft seal

    ok, today i dropped the lower unit out of my 1982 merc 50hp to change the impeller due to no tell-tale water. this is my first attempt at doing this. everything came out fine, but when i looked up into the housing where the drive shaft goes in, i noticed 2 splined gaskets/seals 1 large, 1 small...
Top