Search results

  1. O

    1964 40hp evenrude

    my motor starts right up and idles fine. compression is ok, the carb was rebuilt 3 yrs ago.<br />when I try to run it at WOT it runs about 1/5 speed. when I open the choke cover on the engine cover the motor runs perfect or if I take the engine cover off compleatly the motor runs great.<br...
  2. O

    1964 40hp evenrude lower unit help

    I replacing the hag in the lower unit. when I removed the hag. the next seal in line fell off the shaft. this is a cupped shaped metal rubber seal. I believe this seal gets pressed into the hag. my question is does the cup side get pressed into the hag or does the cupped side face the bearing.
  3. O

    low idle tap

    I have a 63 evenrude 40 hp.<br />At very low idle with the cover off I can hear<br />a tapping sound. when I raise the idle it goes away. Is this something that I should be concerned with.<br />p.s.- 110psi both cilenders. and Im having a carb problem also, no power until I open the choke cover.
  4. O

    fuel or air problem (no power)

    63 evenrude 40hp has no power at wot. I checked compression on both cilenders 110 & 110 psi, replaced plugs. checked spark, engine ran fine with choke cover open, when i closed cover the engine had no power. there is no air filter on this motor where do I start looking? [/LIST]
  5. O

    40 hp evenrude

    I have a 1963 40 hp with electric choke.<br />I cannot get the motor to start. If I spray starting fluid into the carb it will start and run 1 or 2 seconds and die. when I pulled the spark plugs the top plug was dry and clean it looked like it just come out of the box. The lower plug was dry...
  6. O

    1961 seahorse 5.5

    what type 2 cycle oil do I use and what is the mix ratio for this motor
Top