Search results

  1. Z

    YAMAHA 75 HP 2 stroke CETO from 2011 - gauges

    Can anyone tell me which gauges will work with my new engine? I bought 6Y8 tacho and fuel but I heard it won't work...
  2. Z

    Yamaha 75 HP CETO from 2011 what pole?

    Hello, Does anybody know the pole for tachometer and which wire should be connected to it? THX
  3. Z

    RPM's again (Force 85 HP 88')

    Hello, I have a short question for you guys. At last I run my tachometer and at WOT it shows 4700 - 4800. (26 - 27 kn) Is it OK? or little bit to low? Thank you very much.... Engine - Force 85HP from 88'
  4. Z

    Force 85 HP 88' - cable

    Hello, I noticed my cable between engine and console has been cut off :facepalm:. It's 10 core cable and I am wondering whether I should buy new cable or try to repair it. Cable goes under the deck and might have a contact with water. If I need new one, can I buy any 10 core cable or I need...
  5. Z

    Force 85HP from '88 - Main fuse blows every 5 sec

    Hello guys, Yesterday I took my RIB for a ride. After 1/2 hour it started to stop working. On the beginning it was just for 2 - 3 sec (behave like a turn off for this time), then it appeared often and often and then lose power (about 3 - 4 min and then died). I was 500m away from the beach...
  6. Z

    Tachometer problems

    Hello guys, I have bought one of this tachometers (http://greatlakesskipper.com/product/56_76_80-boat-gauges-outboard-only-tachs/763-tg-faria-faria-outboard-only-oversized-boat-tachometer.html), connected to my engine (Force 85 HP 88') on 20 pole and unfortunately it does not work... Any idea...
  7. Z

    Throttle & shaft cables

    Hello, I have just changed throttle & shaft cables and cannot set them (connect to the engine). It looks like shaft cable is too long... (cables are the same as previous ones) I can set rear gear but cannot set front. Do you have any tricks & tips when you connect new cables to the engine? My...
  8. Z

    Push or Pull throttle

    Could you please answer me this "simple" question?
  9. Z

    Gearbox oil drain screw

    Hello, I would like to change oil in my gearbox. I am not sure if part 44 (http://www.boats.net/parts/search/Merc2/Force/85%20H.P.%20%281988%29/856X8B/GEAR%20HOUSING/parts.html) is the correct screw to remove old oil. If yes, do you have any tips & tricks how to unscrew it? I tried with allan...
  10. Z

    Force cable to Mercury - adaptor

    Hello, I need your advice. I bought Mercury control box and would like to use it with 33C cables (Teleflex red one). Do you think this stuff will resolve my problem? http://www.marinemegastore.com/product.asp?src=GBASE&pf_id=BUR_451074&jump=32&cat_id=ENGCON001 Thank you for your answers.
  11. Z

    Force and Mercury Control unit

    Hello, Do you know how difficult is to connect Force 85 HP '88 to Mercury Top mount control lever? Thanks.
  12. Z

    Water pressure gauge (Force 85HP from 88')

    Hello, Can I use any water pressure gauge with sender? What size of thread in sender has to be used? Thank you.
  13. Z

    Trim/Tilt problems

    Re: Trim/Tilt problems Could you please show me where it is?
  14. Z

    Trim/Tilt problems

    Hello, Last year I changed o-rings and oil in Trim/Tilt, but unfortunately it does not keep the engine in up position. I mean it stays for a few minutes but very slowly goes down. Any advice? Thank you very much. PS. Force 85 HP 1988.
  15. Z

    Force '88 85 HP battery cable

    Hello, Could you please wah tbattery cables I should use for this engine? I need to change existing ones, but I do not know the parameters. I need them 3m long. Also, can I connect 2 batteries for the engine? Thank you.
  16. Z

    Patching

    Hello, I need advice how to fix something like this. Thanks for your help, zubol
  17. Z

    End of season service (85 HP from 1988)

    Hello everyone, Because the season is going to be end our engines should be winterised. I would like to ask you (probably there will be more interested people) what we should do to prepare our engines for Winter. And next question - what to do after winter. What check, what change before the...
  18. Z

    Ignition switch for FORCE 85HP from 1988

    Hello everyone, Do you know what kind of ignition switch I need to use for this engine? Can it be any ignition switch for boats or I need a designed especially for this motor? Thank you, zubolmichal
  19. Z

    No electric power. Force 85 HP from 1988

    Hi, After last weekend of fun something happened with my boat :) Electric power just disappeared. No power on tilt&trim switch as well as in ignition. Battery is new and fully charged. Is there any place in the engine with fuses? Can anyone help me? Regards, zubolmichal
  20. Z

    Speedometer, tachometer

    I have Force 85HP from 1988. I would like to connect tachometer, speedometer and maybe temperature gauge. I have all gauges but have no idea how to connect them to the engine. Could anyone help me and give me step by step instuction? Thank you very much, zubol
Top