Search results

  1. Z

    slow mixture needle has a flat spot 61 rude 40hp

    can you fix these dents by filing or something or does it have to be replaced?. as long as it fits in the seat it should be fine RUNS terrible then if I move it a fraction it starts to smooth out, turn it again and the whole engine shakes, there is only one area on this needle where it's runs...
  2. Z

    PINION BEARING 61 40 HP EVINRUDE

    DOES ANYONE have a picture of this bearing dementions???? mine is froze in the housing ?
  3. Z

    DISCONTINUED HIGH SPEED NOSEL???? 1961 RUDE 40 HP LARK III

    Nobody has this nosel discontinued 1962 it's gone fuel runs down the channel and up threw the carb and right out the front of carb when prime bulb squeezed , sometimes it don't!!!!! sometimes hard and sometimes not??? is there something else I can put in there????It's the fast jet in the...
  4. Z

    IMPELLER WATER PUMP

    61 RUDE LARK III 40 hp MODIFIED TO A LONG SHAFT WATER DRIBBELS OUT Is that because it's been modified and has to travel 20 inches or is a sign of inspection and water pump kit?
  5. Z

    yall motors don't stay running ????

    once mine starts . I can't turn the S.O.B. OFF no ignition FORD SELONOIDE pushbutton start, I have to install a kill switch from the condencers. I swear I could leave the boat at the dock with the engine running go to bed and get up the next morning and that damb thing would still be...
  6. Z

    i dunno

    tired of talking about them ,,,, I'm tired of fixing them. :rolleyes:
  7. Z

    1961 EVINRUDE LARK III 40 HP modified LONG shaft

    Well here's a classic motor : Just have a 13,394 questions . . . jk he he he serial no. 10194 model 55224 well where do I start any information at all on this engine would be appreciated . . . it's hard to ask simple questions about this 1961 evinrude 40 HP LARK III <br />because...
Top