Search results

  1. S

    would 20hp work on this setup?

    good day. I'm considering a 20hp 4 stroke tiller on my 14.5ft fishing boat. total weight for boat plus people/gear/batteries/motor etc is likely over 1100lbs. rated for 30hp. Would a 20hp plane this setup and what kind of top speed would it get? Thanks
  2. S

    97' 25hp johnson aftermarket water pump kit issue

    I got an aftermarket water pump kit and it appears the housing is slightly higher and the rubber grommet that went ontop of the housing doesn't fit now. did they update the design to not need the grommet? concerned about a good seal from the housing to where it mates with upper half of motor...
  3. S

    25hp johnson - lower unit seal kit how to

    im going to order a seal kit for my late 90's johnson 25hp 2 stroke. is there instructions on how to install the seal kit? not sure how difficult this is or anything to watch out for. Thanks
  4. S

    25hp Johnson - gas going into oil tank, want to disconnect oil injection

    Good morning. Picked up a late 90's Johnson 25hp that appears to have gas going into the oil injection tank. From what I understand, something has failed on the fuel pump/diaphragm which is causing this. Compression is 90psi on all 3 cylinders cold (don't want to run it until issue fixed), so...
  5. S

    Fuel pump strength on 6hp and 9.8hp 4 strokes

    Does the fuel pump on these models have enough strength to tie into an under floor gas tank? I'm thinking of scrapping the portable tank and tying into my main tank, but wasn't sure if the longer run and gravity would play a part with these smaller motors' fuel pumps. thanks
  6. S

    draining carb after use on 9.8mfs

    I've noticed that pulling the fuel line off and letting the motor run the carb dry after each use really helps on starts - usually starts 1 or 2 pulls every time. I'm wondering though, as it didn't do this when I wouldn't drain the carb - why does it do this? I'm questioning if the carb floods...
  7. S

    Spark plug colour?

    I had the 9.8 out for a ride and pulled the plugs. They seem a bit white but both have similar color. I'm just wondering if I might need to clean the carb. Do you think they look a little on the lean side? Oil level is 3/4 full and compression is good and tight on both cylinders.
  8. S

    Prop for 9.8 Tohatsu 4 stroke based on my setup and RPM readings

    took the 9.8 out for a run the other day on my 1500lb boat. Looks like I'm getting about 4000-4200rpm at full throttle. The prop says F8.5 so I'm guessing its the stock 8.5D 8Pitch prop on there. Based on my readings above and weight of the boat, what prop would best suit my setup? I am hoping...
  9. S

    25w-40 synthetic blend merc oil...work in cold?

    I have a 50hp merc 4 stroke and am currently running the Merc Outboard 25w40 synthetic blend oil. I've heard that regular 25w40 oil isn't recommended to use when its colder than 4c. I'm not sure if being synthetic helps with the temperature range. Reason being might want to go on one last trip...
  10. S

    Tilt up bracket on 9.8 msfa3 - spring loaded?

    Hi all does anyone know if the tilt bracket on the 9.8 mfsa3 should be spring loaded? Its the mechanism with the side handle to latch the motor right out of the water. It automatically locks into shallow water mode (i can see the spring on the bracket) but the full up position isn't locking...
  11. S

    Merc 9.9 4 stroke Side (or front) shift conversion kit?

    Hello, Does anyone know if its possible to convert a newer 2007 Merc 9.9 tiller shifter to a side shifter or front shifter? Don't really like the idea of the shifter built into the tiller throttle. I see a few part numbers but they don't list specifically if it will work on the 9.9...
  12. S

    Tohatsu 9.8 - feature changes in recent years?

    Guys I'm after a Tohatsu/Nissan 9.8 and was wondering if there has been any major changes since 2007. Looking at these years and above and if there are any main differences I'd like to know them. Otherwise these are a solid motor correct?
  13. S

    How often should you replace fuel lines?

    My boat is around 15yrs old and notice the fuel lines are permeating pretty bad. No signs of cracks but was wondering how often the hoses should be replaced on the tank and fuel feed lines?
  14. S

    50hp Merc - Hissing noise coming from fuel pump after priming bulb

    I have a carb'd 50hp merc and notice the fuel bulb loses prime fairly quickly after priming it up....whether starting it or not. After priming up I notice I can hear a hissing noise from the fuel pump on the motor where the in/out hoses go. Can't see any gas leaking and the gasket seems tight it...
  15. S

    long or short shaft kicker on V hull?

    I currently have a longshaft kicker that sits on the side of my boat. My main motor is a long shaft. The way the "V" is on my boat, where the kicker sits is only about 16 to 17'' from top of transom to the bottom of boat. I'm wondering, would I be experiencing significant performance loss with...
  16. S

    Raising transom for kicker motor

    Hi I'd like to see if I can find a product that can raise the transom for a kicker motor (needs to go up 5 inches. Is there something that can just clamp to the transom and raise it (motor is 60lbs)? Would like to avoid drilling through if possible. Thanks!
  17. S

    6hp 4 stroke vibration

    I have a 6hp 4 stroke mrcury and I notice it really vibrates on my boat at all speeds (worse at higher speeds it seems). Its too the point where it shakes the whole boat and my hand is numb from holding the tiller. Afterwards noticed one of the bolts was loose down by the release mechanism (1 of...
  18. S

    1 or 2 gallon gas tank available?

    Hi all, is there a 1 or 2 gallon gas tank on the market for outboards? I have limited space and would prefer this size for a 4-6hp motor. Thanks!
  19. S

    Tohatsu Guru - questions about 4-6hp's 4 strokes

    Looking at getting one of the smaller 4strokes and was wondering if there is any model year range that I should look for or any significant changes that would make the newer ones better. Been looking at year 2000 and up so not sure if they've changed them much since then (like...
  20. S

    Convert Yamaha 4 stroke 4hp to 6hp?

    I'm looking at a 2000 Yamaha 4hp motor and was wondering which model years can be upgraded to a 6hp with a carburetor swap? Or are more parts needed to do this? Thanks!
Top