Search results

  1. L

    89' 70hp evinrude shifter linkage?

    Just rebuilt my 89' 70hp Evinrude. Had engine completely disassembled. While I had everything apart I also put on a new water pump and new seals in the lower unit. I did not completely disassemble gear box but just replaced the input and output shaft main seals (which had been leaking) and...
  2. L

    E70TLCEM Water leak

    I had water leaking out the mid section of the motor just above the lower unit. After removing lower unit to replace the water pump I noticed the water pump gasket had a blow out about 3/8" long. Thinking this was the culprit I replaced the pump and housing just as the service manual states...
  3. L

    E70tlcem

    Trying to get lower unit off my 89' 70 HP Evinrude to replace water pump. Held up by shift linkage I think. Not sure how to disassemble linkage rod below carbs. Loosened 1/4" bolt on shaft but it won't slide off. There is a small pin maybe 1/8" that holds linkage together. Does that just drive out?
  4. L

    1989 70 hp evinrude

    Last couple times I've had boat out engine starts and runs fine till it warms up then starts to run rough. Engine would still idle and open up but shook a little. Yesterday while running wide open engine fell on it's face and only running about half power. Engine wouldn't idle and water pump not...
  5. L

    1953 7.5 fleetwin evinrude parts?

    I have a model 7512 and I need a clutch lever support collar part #203115 and a propeller shaft cap part #201880 and a carb rebuild kit.
  6. L

    1989 70 - Remote Wiring Diagram (in color)?

    Re: 1989 70 - Remote Wiring Diagram (in color)? I hope this is what you need. If not I have the rest of the color images that came with my service manual. Let me know what you find out. I just checked my temp horn the other day like the manual said and mines not working either.
  7. L

    89 E70tlcem

    While rebuilding my carburetors this weekend while I had the primer lines off the carburetors I squeezed the rubber manual fuel pump bulb on the main fuel line and gas shot out those primer lines. I read somewhere in the service manual last night that with the red manual primer valve in the...
  8. L

    1989 70 hp Evinrude occasional starting issue

    Rebuilt carbs this weekend. Went great! Went through link and sync procedure except didn't have timing light with me at lake. Set throttle plate sync back where it was and left idle speed the same. Started on earmuffs ran fine 1100 - 1200 rpm. Put it in lake and it started right up and ran great...
  9. L

    1989 70 hp evinrude carb rebuild

    I have an E70TLCEM that came on a pontoon I bought this year. I have had all kinds of trouble with it idling and starting in the water. I've taken it to a mechanic twice and with the same results. It runs fine for the first day or so but progressively gets harder to start and doesn't want to...
Top