The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
Hey guys,
Just recently did a tune up on my 97 merc 115HP. Changed the plugs out with what a local boat shop recommended, NGK BP8H-N-10. The boat runs alot better now but I'm getting engine noise through my VHF radio.
I've been doing some research and everyone has been telling me to change my...
I have a 1997 Merc 2 stroke 115HP. My trim guage shows the motor as being down when I have it all the way down, but the minute I trim it up just a tiny bit, the guage needle slams and shows the motor as being all the way up.
Do I have a bad sensor or bad guage?
I'm not even sure where the...
I have a 1997 Welcraft 190ccf and cannot for the life of me figure out a spot to put a fish finder transducer. The unit is a Raymarine DS500X. I'm open for either thru-hull or transom mount.
It has a stepped transom which only has about a 2 inch lip, not enough room to put a transom mount...
I have a 97 Merc 115HP 2 stroke outboard.
Just doing a tuneup on it and it had Autolite 4092 in it. I called the local boat shop and they said that engine takes a NGK BP8H-N-10
Does this sound right to you? Or is there a better plug for this engine?
Also what would the plug gap need to be...
Hey Mike,
If you're out there, I could use some help. I was reading your posts about the wellcraft 190ccf scupper drain problem. I just bought a 1997 190ccf last week and took it out for my first run this weekend. A half hour of running around and I had a gallon or so of water in the bilge...
Hey guys,
I'm going to be replacing my throttle control on my 97 Wellcraft. The arm stripped out due to a loose set screw which is now corroded and frozen in. The merc replacement part is a 88688A25
My question is, how hard is it to swap one of these out? Are the cables easy to unhook and...