The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
at normal operating temp. what should my motor run at? i installed a new temp guage , wiring , temp sensor and when running in the water for about the temp gauge only reaches 120f . the water comming out the motor feels warmer than 120f. the temp of the bay water today was 76 f. just...
just got a 1994 1802 in pretty good condition. i noticed today a fuel smell comming from the bilge area. sure enough opened the hatch and there is fuel laying in the bilge. so i shut off and disconnected the batteries , top of the tank is dry, all fuel lines are dry, top of sending unit and tank...
i have a 94 90hp force. it has the motor/hydrolic pump on the left side , the 4 lines all go into the bottom of the pump. i know i have air in the lines and piston assemblies. what is the best way to bleed the system.motor is new and i made sure the shaft from the motor is spinning the pump...
just got a new pump assembly from northern marine, put pump assembly on motor, connected the 4 lines to the bottom of the pump , filled res. with fluid. tried bleeding it for 2 hours with no results . the shaft that drives the pump is spinning. it seems like the pump is not pushing the fluid...
just traded my 1989 aquasport 175 center console for a 1994 trophy with a 1994 90 hp force. motor runs awsome it has been rebuilt 1 year ago. my question is : i run the motor in a 55 gallon drum because the muffs dont fit to good over the water intake , after flushing the salt from the motor and...