Search results

  1. L

    Buy a yamaha?

    Hi guys. So iv been battiling it out with my 1989 force 125 for quite a while now. I went to get the crankshaft worked on, and while it was on the laithe it was quite obvious that the crank was warped. So iv decided its time to repower. Im looking at a 1994 yamaha 130. Whats the rep on these...
  2. L

    Force 125 Crank Walk

    Hey, everyone. I gotta 1989 Force 125, and as the title suggests my crankshaft shifted downward, driving the flywheel into all the nice expensive electrical parts on the top motor. So I took the powerhead apart to examine everything and try to determine what went wrong. After taking it apart and...
  3. L

    Mercury Flywheel removal

    Hi, I got a 1989 mercury 115. I am trying to remove the flywheel, but it just wont come. I removed the crankshaft nut on the top. Is there anything else that has to be removed, like a key way or snap ring. Iv broken three bolts, and my puller trying to get it out, so any help is greatly...
  4. L

    120 Merc not working

    Hi, just purchased a boat with a 1989 rebuilt mercury 120 two stroke on it. The first two times i took the boat out it ran great. The third time, it started fine, we went about a mile off shore, and decided to go for a swim. When I went to go restart the motor it wouldn't start, and hasnt since...
  5. L

    Omc Trim oil

    Hi, gotta a 3.8L omc with 800 series drive. Trying to get my power trim system up and running and wondering what kind of oil to use. Should i use hydraulic, or would power steering fluid work. Thanks
  6. L

    Omc Trim Pump

    Hi, I have a 1981 omc 800 series powered by a gm 3.8L V6. The trim system is working properly. I am wondering if there is such a thing as a pump rebuild kit. Also does anyone know the specs on the pump (what is the pressure output, etc) because I am thinking of just hooking up a similar...
  7. L

    Omc tilt problems

    I have a 1981 omc 800 series powered by a 3.8L gmc v6. I have rebuilt the entire boat from hull up. Now I am trying to finish it. I just installed the tilt motor and trim motor, but neither will work. The motors were both rebuilt a long time ago(boat was last in the water in 1996) so they are...
  8. L

    Omc Ball Gears

    I am re-assembling my omc drive-shaft. I have the ball gear, but none of the old shims. Looking at the seloc repair manual I am a little confused as to how I measure for new shims. Anyone have any advice or good tricks. Thanks. It is a 1981 omc 800 series.
  9. L

    Omc Steering

    As mentioned earlier I have a 1981 omc 800series powered by a 3.8L Gmc V6. I am trying to find out how the power steering and related equipment is hooked up. If anyone has a similar model, can you please send me some pictures, it would be really appreciated, thanks. Here is a link for a parts...
  10. L

    Omc Steering

    I have a 1981 omc 800 series powered by a 3.8L GM V6. I am trying to figure out how the power steering is hooked up. I have what looks to be a hydraulic ram, which is connected with hydraulic lines to another hydraulic apparatus. This "apparatus" is then connected via cable to the steering...
  11. L

    omc trim pump

    Hi I have a 1981 omc 800 series. it is powered by a 3.8L GM v6. I am looking for where the hoses from the trim pump go to the mounts. Any advice is much appreciated. thanks
Top