Search results

  1. P

    Need Help with Honda Model Year Identification

    Can someone help me determine the year of a used Honda 7.5hp outboard motor. The model # is BF75L 1300517. Any help would be greatley appriciated Thanks, Pat
  2. P

    Volvo Penta Outboard

    I recently purchased a Volvo Penta outboard. Can someone help direct me to a website where I can learn obout these motors. The model is a 34cc longshaft. It appears it is air cooled? Any help would be appreicated. Thanks, Pat
  3. P

    Mariner Model Year Help

    Can someone help me determine the year of my Mariner outboard and the horsepower. I purchased this motor without the cover. I believe it is a 4hp. Also, can someone recommend a place where I can purchase parts for this outboard? M4 6EO S Serial Number 106141 Any help would be appreiciated...
  4. P

    Idle RPM Adjustment on 200hp Johnson

    I am in need of some advice on how to increase my idle rpm's for my 200hp Johnson Ocean Runner. The motor is the carburated type. Is the best way to adjust the cable that enters the cowling using the threaded nut? Where should the idle be running in nuetral? Where should the idle be...
  5. P

    200HP Johnson Stalling at idle, Help

    I have a 1998 200hp Johnson Oceanrunner with carburators that is starting to stall once I shift the throttle back from the minimum trolling speed into neutral. The motor restarts no proplem after it stalls and runs fine at any speeds above 1000rpm. The stalling happens about 50% of the time...
  6. P

    Lower Unit Removal Help, 3hp Johnson

    I could use some help in the procedure for removing the lower unit on my 3hp Johnson. It is a 1996 3hp with forward and nuetral shift. I removed the two bolts holding the lower unit in place but I can not find the shift linkage disconnect. Any help would be appriciated. Thanks, Pat
  7. P

    Water Pump Replacement 200hp Ocean Runner

    I just replaced the water pump in my 1998 200hp Johnson Ocean Runner. I replaced the impeller and housing(bought the kit). The job seamed to go very smooth. My question for the group is: Should there be excess water coming out between the space where the lower unit bolts to the intermidiate...
  8. P

    3hp Johnson Reving problem

    I recenty purchased a 1966 3hp Johnson. The motor starts fine and idles fine. It will not rev up past idle. It stalls out if I leave it near full throttle. It did start to rev after I closed the gas supply line and began to run it out of gas. The motor has been sitting around for a few...
  9. P

    200 HP Ocean Runner Head Gaskets

    I recently purchased a 1998 200 hp Johnson Ocean Runner. The motor has 350 hours total. I have been told the head gaskets begin to leak over time and small amounts of water enters the cylinders from the cooling passages. This results in washing the oil off the cylinder walls and scores them...
Top