The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
Has anybody had any experience with the new Yamaha F-70 four stroke with single overhead cam? I love the power to weight and the fact that it is a four stroke. I'm thinking of repowering my 22-2 aquasport with a set of twins, but was wondering if they have any kind of a track record yet...
I've had this happen with increasing frequency- while trolling, my 115 SPL just comes to a dead stop with no warning, no other oddities whatsoever. Most times, it starts right back up, if you restart it right away. If you leave it sit for a half hour, it is hard to start and takes a long time...
My 1997 115 SPL just turned 1300 hours. It still runs fine and the last compression check was perfect. About how many hours could I expect to get before it's time to repower or rebuild?
After doing a fuel tank replacement in my boat, I fired up the motor and it started up as it does every spring. Problem is that at idle, every 15 seconds or so, the motor "pops". When on the muffs, you see a large puff of smoke out the prop hub when it happens. Sometimes, it coughs so hard...
When putting 115 spl, 1997, away for winter, found a ball of fishing line behind prop. Unwond it and removed, had some peel out from behind the seal around the prop shaft. Seal around shaft is not torn up and looks ok. Do I need to take apart and reseal? Lower end oil looked OK when I drained.
Was running WOT about 2 miles out when RPM fell off suddenly and engine died. Checked fuel line connection and primer bulb, both OK. Turned key to restart, hard cranking for one revolution, then fired right up. Headed back to shore, ran OK. Ran along shore line for 2-3 miles at WOT, no...
Evinrude E115TSLEU. I thought I had a problem with the fuel primer solenoid. I was getting no fuel at startup when depressing the key. Engine would start and run normally when you would move the throttle wide open a couple times before starting. I was getting no "click" noise from the primer...
115 Rude, 1997 model. Mod#E115TSLEU. Starboard side upper ignition module has about a 1/2" square piece of plastic missing on the end. The plastic piece encases the silicone like substance that looks like it seals the inner components of the power pack. The motor runs fine in the test...
I have a 22" CC and the hydraulic steering lines are showing signs of rot and dripping in some places. I'm afraid if I change lines, I'll have a heck of a time bleeding the air out and getting things back to where they were. It looks like the ram in the rear by the engine is the reservoir and...
Motor runs well at around 3500 to 4000 rpm. At WOT it starts to lose rpm and power. When this happens, the primer bulb completely caves in. Last season, I installed a Raycor filter/water seperator with 3/8" lines (Raycor part # S-3227, rated at 60 gph flow). I checked the tank vent, which is...
