Search results

  1. C

    flushing question

    I bought a 2007 Johnson 9.9 which is the same as the Suzuki DF10. I bought the recommended flushing attachment from a BRP dealer, part #5031537. I can't figure out how to attach it to a hose? Obviously, you remove the flushing screw from the lower unit and screw one end in. But the other end is...
  2. C

    Engine Flushing

    I bought a 2007 Johnson 9.9 which is the same as the Suzuki DF10. I bought the recommended flushing attachment from BRP, part #5031537. I can't figure out how to attach it to a hose? Obviously, you remove the flushing screw from the lower unit and screw one end in. But the other end is fairly...
  3. C

    Kicker height mounting

    I have a 22' boat with almost no deadrise at the 19 inch transom. I bought a new Johnson/(Suz.) 9.9 4 stroke long shaft kicker, principally for trolling. I am designing a fixed transom jack plate with 6 inch setback. To get the motor to it's best operational height I am shooting for getting the...
  4. C

    89 Ev 15 short to long.

    I own a great running 89 2 stroke 15hp Evinrude short shaft. I really need a long shaft for a trolling motor/kicker on new 22 boat. I know mine is in great shape. but my transom is about 19" where the kicker would go. Looking for advice on best option to pursue: 1.Buy an extension kit. 2.Sell...
  5. C

    thinking new T6 or N6 2 cyl vs 1 four stroke?

    is their a real benefit to 2 cyls vs 1 in Tohotsu? Are these good motors for a high hour trolling motor/kicker for a large boat (3000# loaded) for displacement speeds? chris
  6. C

    embarassing question 86 J8

    I cleaned my carb and i can't remember which hose goes to which nipple. One leads into the primer, the other comes from the fuel pump. Which one goes to the lower nipple at the bottom of the float chamber? I can't find a viable answer in my manual. thank you, chris
  7. C

    compression small johnson 86 8hp

    What should the compression be on one of these that has just been overhauled? I can't find it in my manual. I just ran a cold test on mine at 85 and 90. While they're not that far apart, they both seem awfully low compared to other outboards i have tested. Is it about time for an overhaul...
  8. C

    Timing problem maybe?

    i have an 86 johnson 8. it was running ok but i decided to rebuild the carb. now i can start it ok, and rev it ok for a few seconds, but then it just dies quickly at higher revs. i think, in trying to sync it, i may have goofed up the timing. but i can't get a gun on it before it dies out...
  9. C

    tricks in troubleshooting fuel syst. leaks

    i have dual tanks with a switch and a water seperator and 2 motors attached. i have been working for several days trying to find out where the system is losing its seal (I cannot get the bulb to firm up like it should). i've tried double clamps, isolating parts with vice grips, no luck. what...
  10. C

    my leaking Johnsons

    I have a 1986 70 hp 3 cyl and an 85 8 hp 2 cyl kicker. if after running them, i leave the fuel lines attached i end up with fuel/oil leaking down the lower unit and dripping on the ground. the motors run fine, but i have to unplug the fuel lines at the end of each trip and burn 'em dry to be...
  11. C

    stator?

    after months of working on my 98 J15 4 stroke with no spark, i found the stator to be slightly out of ohm spec. so, i ordered a new one from iboats and it came today and, well, it's way further outside the specs than the old one! it's a darned 3 piece ignition system! rats, this is driving me...
  12. C

    when did etec first debut?

    and was it revolutionary change from the year before?
  13. C

    98 J15 Stator

    all ohm tests on the stator are within spec, yet i can't get more than 8.4volts out of it on the rope crank. (spec should be north of 70volts). cranking volt tests on the brown leads seem to show some leakage to the negative leads indicating a probable stator short. The manual says either to...
  14. C

    Really confuzzzzzed!

    I have a 98 Johnson 4 stroke rope start. The codes are FRLECM which I read as 4Stroke;Rope Start;Long(20)shaft;98;M production run the first thumbnail is the actual motor, with the plate on it. I am looking at another motor that is the same year and the seller says it is also a long shaft, 20"...
  15. C

    is there a fuse on my 98 4 stroke J15 with a rope starter?

    where would i find it?
  16. C

    johnson/suzuki

    does anyone know what years 95-05 15hp johnson 4 strokes were made by suzuki?
  17. C

    can anyone tell if this coil is within spec?

    this coil is off my 98 4 stroke johnson 15 rope start, the picture shows ohm values from my ohmmeter. open indicates no ohm reading at all. is this thing dead? thank you, chris m.
  18. C

    98 J15-4S rope, no spark.

    have isolated that the e-cut off is working properly. ground circuit opens with lanyard, closes when lanyard is pulled. I have a double coil attached to the plug wires. The small red wire input is showing 0.00 ohm continuity with the engine block! Is that correct or is that my problem, a...
  19. C

    Purchasing 1994 Trophy 2302 WA /questions

    What were the weak points on these boats? I have heard about wood stringer failures as well as soft spots in floors. What should I know before I commit? Probably needs to be repowered. Has Merc 175, is this the ideal size for general fishing use? Anyone own this model I would be interested in...
Top