Search results

  1. A

    Johnson serial #

    I am getting a free 2000 150 Ocean Pro next week. I have the serial numbers but I can't seem to find what "V" means. The serial # is J150VXSSS. Anybody know? Thanks Mike
  2. A

    Old Evinrude ID

    My buddy gave me an old engine and I can't seem to find out what HP or year it is. The numbers I got off the bracket plate are 10302D- E11152 Thanks in advance Mike
  3. A

    Correct Rectifier?

    86 johnson 225 tlcda I purchased a rectifier (sierra # 18-525) from iboats for my engine. When I received it today the label says it is for a v4, v6 crossflow. It also has no purple wire. A note was sent with the package stating it is no longer needed due to design improvements. Will this...
  4. A

    Trim Problem

    86 Johnson 225 on a 79 21' Cruisers Inc Bonanza When the engine is trimmed all the way the front of the cavitation plate of even with the keel and the back of the plate is about 1/2" higher. The thrust rod seems to be in hole closest to the transom Is there any other adjustment to get the motor...
  5. A

    Inside the Remote Control

    J225TLCDA I have a problem shifting into forward gear. I tried adjusting the cable as per my service manual and I still could not get forward. Reverse is no problem. I thought it might be a stretched cable, so I purchased a new one. While installing the cable I noticed that inside the remote...
  6. A

    86 225 johnson with a strange starting procedure.

    I've been trying to get the engine to run at idle wih no luck until today. I had the air silencer cover off, primed the bulb, fast idle lever up, pushed choke in and tried to start it. No luck, just cranking away like its not getting fuel. Pulled a couple of plugs and no fuel on them. After...
  7. A

    No water from telltale (86 Johnson 225)

    I've been reading posts about the possible causes of having no stream from the telltale. I put in a new waer pump, new stats, cleaned out all the water lines and passages. I get a strong stream without the stats in, once their in- no stream. I'm somewhat confused on the route the water takes...
  8. A

    Testing for Battery charging

    86 johnson 225 How would I go about testing if my batteries are charging with a Blue Sea Add a Battery System installed. With the engine running I tested across the batt terminals and got a reading of 12.6ish volts. I know the relay controls the charging some how. I'm a little suspicious because...
  9. A

    86 Johnson 225 No Spark

    I have no spark on all 6 cylinders. After reading the manual and reading posts on this site here are the tests and results All plugs removed, spark tester set to 7/16" gap, red plug disconnected, jumped the starter- no spark Disconnected the black/yellow wire connector to each power pack- No...
  10. A

    Intake manifold hose

    A quick question regarding the nipple of the bottom of the intake. All the nipples are clear, meaning I can blow air through them except for the one shown in the pic. Before I go any further should this passage be clear like the other ones? Johnson 225 1986
  11. A

    Lower Unit Problem

    The shift rod needs to be replaced. It looks like the prior owner tried to cut it. I have the gearcase separated and in my garage. The bearing carrier, reverse gear, snap rings and washers are all out. In order for me to push or pull on the shift rod I need to use vise grips, it won?t budge by...
  12. A

    flywheel and stator question

    Is there a magnet missing on the flywheel or is that space supposed to be there. Also can the rusty part of the stator be cleaned or should I just leave it as is 86 Johnson 225 TLCDA Mike
  13. A

    Kill Switch

    The kill switch on my OMC remote control (86 Johnson 225) is no good. I removed the switch and tried to find a replacement. No such luck, I can't find one. I purchased the Saf-t-stop switch only to find out that it doesn't fit. The problem is the tension adjustment rod for the throttle handle...
  14. A

    Odd Compression Test Results

    The motor is a 86 Johnson 225. The compression test I did yesterday gave me an odd result. I used the old gaskets which where removed and put back a couple of times for the test (not the best idea). First test showed Cylinders 1,3,5 at 78,85,90 and Cylinders 2,4,6 at 56,55,63. The second...
  15. A

    Shift rod

    I have a 1987 225 hp and it needs a shift rod. I can't seem to find a parts supplier that has one. Anybody have any recommendations?
Top