The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
I cant figure out where to put the T&t fluid in my 1995 90 h.p Johnson ML? When I try to raise or lower it the relays click and it doesnt move. It was working and just quit? Any ideas?
Some one left the radio on for a few days and the battery went dead. I charged it and now only get a slight clicking. Changed batteries,same thing. All the connections are tight and clean,circuit breaker checked. Power tilt and all accessories work. Its a 1997 3.0lx with less than 60 hrs.Any ideas?
My needle wiggles and jiggles. At WOT it goes past 240,reduce speed slightly and it rapidly drops to 190. At 35mph or 4600rpms it reads 190. In no wake it reads about 180 after about five minutes. When I give it the gas it imediately goes to approx. 230 then comes down to about 190. Confused...
Merc 3.0 temp guage reads all the way hot most of the time.Needle flickers back and forth,between 160 and past 240.Water is spraying out the back. Where is the temp sending unit located? Any tricks?
Someone said maybe new impellor might be turning the wrong way. If I bent the tips counter clockwise and the key is in,doesnt it have to spin only one way. Im not getting any water to the thermostat. It bubbles like crazy in the garbage can. Is $50.30 crazy for just a thermostat? !966 Evinrude...
On a 1966 Evinrude If the impellor spins clockwise the ends should be bent towards counterclockwise right? I only noticed the shift shaft and drive shaft sticking up from the lower unit. Is there one sticking out of the top to transport the water? I still have no water to thermostat. You guys...
I just bought a boat with a 1966 80 hp Evinrude. The seller Said it might need a new water pump so I changed that but it was still too hot to touch. I then was going to change the thermostat and decided to start it to see if there was any water flow. With the thermostat housing open and the...
I just bought an old boat that had a burned out light bulb. When I put a new one in it lit up then the wired behind it really started smoking. They werent bare or grounded. Any ideas. It was a front light. 12volt. Pontoon
I have an old Johnson 35. The rope pull got jammed and I took it off. Just the cradel on top. Can I still just use the electric start and use it that way with no harm?
I just got a 70s Evinrude 80 H.P. and changed the water pump with no problem,but Im not sure where the water intake and exhaust is to know if its working?
