Search results

  1. T

    1997 50 hp wire harness

    I am looking for a 18' wire harness for a 1997 50 evinrude. I need not only the wire harness but also the ignition switch harness and oil temp buzzer. Does the wire harness have a pig tail on the console end for hooking up the oil and temp buzzer and ignition switch? Are such wire harnesses...
  2. T

    1997 50 HP control & wire harness

    Hello everyone I just purchased a 1997 50 hp without the remote control, cables, or wire harness. I am installing it on a project Pontoon boat. I would like to install a binnacle control. The outboard ser# is: E50TSLEVS Question: Does the wire harness include the battery cables? Thanks
  3. T

    Starter Torque Damages Powerhead

    Has anyone had the starter damage the powerhead? I purchased a used 1995 40 hp force. I removed the starter and discovered the starter-mounting stud was broken in half and a corner of the starter-mounting surface, which has a bolt thru hole in it, had broken off the powerhead. A local boat...
  4. T

    Powerhead removal 95 40 hp force

    I am preparing to remove my 1995 Force 40 hp powerhead. My maintenance manual says to remove the flywheel nut and install a "lift eye" then attach a hoist to the lift eye. I do not want to purchase the lift eye tool as this is going to be a one time removal and re-installation. (I hope)...
  5. T

    95 Force 40 HP dies at W.O.T.

    My 1995 Force 40 Hp dies at wide open throttle (WOT) Before it dies it runs a little rough. This rough running is not noticeable unless you listen very carefully. However, if I ease back on the throttle very slightly the engine will not die. I do not have a tach onboard so I don't know the...
  6. T

    Swaping out lower units

    Will a lower unit on a 1995 40 hp Force serial number: OE139567 bolt up to a 1994 40 hp Force with serial number: EOE24374 ? Thanks in Advance!
Top