Search results

  1. B

    Where to buy new engine??

    Hello I'm in process to replace engine on my boat,1988 luhrs single inboard engine 5.7 PCM There is many different suppliers but i can decide where to get one and not get burn or buy lemon. I would go with new one 5.7 carb complete engine turn key over 300hp not necessary pcm or any particular...
  2. B

    Loss of power over 3000rpm

    Hi I have 1988 27' luhrs with 350 chevy PCM, borg warner tranny and straight shaft. Up to 3000 rpm runs good but when i push the throttle over 3100 rpm toward WOT engine losing power and boat slowing down instead getting faster. On 3000 rpm boat speed is 10-11 knots which is not fast enough i...
  3. B

    Removing shifting rod on johnson15 hp 1980

    Hi I decide to covert my short shaft johnson 15 hp to long shaft Have all parts but i cant remove shifting rod to install long one for long shaft. Is there any catch how to do it or i suppose just un screw it from the bottom. Iam trying with pliers from the bottom it wont go. thanks
  4. B

    Johnson 15 no water thru the pee hole

    Recently bought used 1980 Johnson 15hp for $300 and today I start the motor with rubber ears with open water running thru.But when engine running no water coming out thru the pee hole. Except impeler what else could be no good? What should I look at first? Thanks
  5. B

    Changing short to long shaft?

    I have 1980 Johnson 15hp short shaft and I was wondering if is possible make it long shaft by changing lower unit or any other way? Thanks
  6. B

    Boat makes wide turns.

    Hi Have 27' luhrs single screw with direct drive and to me seems like it makes wide turn when I turn wheel in to one side.When I leaving or coming to dock have a little bit of trouble.I don't know if it has to be like that or maybe I used to out drives because I had twin maxum before this one...
  7. B

    Bravo 2 out drive service manual

    Hi Where I can find service manual for my bravo 2 drive 1998 Drive SN# 0L162089 Engine SN# 0L067325 Thanks
  8. B

    Fuel pump doesn't get power

    Hi I have 1998 mercruiser 5.7 EFI and my port engine fuel pump doesn't get power. I try switch releys and ECM from starboard engine but still nothing Olso I check with volt meter and power don't come when ignition is on or engine is cranking. When I spray little bit of starting fluid down the...
  9. B

    Mercruiser 5.7EFI just died on me and seems to be hot.

    Hi Today I was coming back to marina port engine just shut off and I didnt want to start again,so I get back on one engine. I open engine hatch went down and exaust manifold on the port engine are very hot but the starboard engine just warm like should be. Temperature Gage read 175f on a both...
  10. B

    Macerator pump leaking

    I have Jabsco Macerator pum in my maxum,and today i notice the pump is leaking so i wonder is it repairable or i have to buy new pump. The leak is visible in the middle of the pump right there between electric motor and pump it self.
  11. B

    Beeping sound

    Hi i have maxum 3000 SCR 1998, just bought the boat couple weeks ago,so still new in boating. When i turn ignition key on port engine beeping sound you can hear every time, but starboard engine doesn't beep every time and when is not beeping engine wont start. But after a little time beep...
  12. B

    Beeping sound

    Hi i have maxum 3000 SCR 1998, just bought the boat couple weeks ago,so still new in boating. When i turn ignition key on port engine beeping sound you can hear every time, but starboard engine doesn't beep every time and when is not beeping engine wont start. But after a little time beep...
  13. B

    I want to by 1998 Maxum 3000 SCR

    Hi I just put deposit on 1998 Maxum 3000 scr Boat is bank repo so i can get it for less then is regular price.I like this boat it has a lot of room in and out,looks beautiful. Boat has twin 5.7 mercruiser engines,dont know the condition of the engines until survey is done. I am looking those...
Top