Search results

  1. J

    stern bracket replacement for '77 Johnson 35hp

    hello guys, Anyone know if this starboard stern bracket from a 95 Johnson part number 0342536 STERN BRACKET, Assy., stbd. would work as a replacement for the starboard stern bracket for a 77 Johnson 35hp, part number 0388039 | STERN BRKT., ASSY., Stbd? From the microfiche, it looks like it...
  2. J

    OMC trolling motor bracket-looking for obsolete part

    anyone know where I might be able to find this part? 0395598 BRACKET, Motor tube --- BRACKET, Motor tube Thanks!-Jeff
  3. J

    replacing coils on 77 johnson 35 hp

    Hello Guys, I'm planning to replace the coils on my 77 Johnson 35 hp. It looks pretty basic, unbolt, unplug the old ones, bolt back in and plug back in the new ones. Any pitfalls I should be aware of? Thanks!-Jeff
  4. J

    77 Johnson 35hp oil nipple

    Hello Guys, Went to replace the oil hose that runs from the manifold to the crankcase, and the nipple at the bottom of the manifold slid right out of the block with the hose. I'm ordering a new nipple, but was wondering what is supposed to hold it in place? Does it just seat in the block with...
  5. J

    77 Johnson 35hp

    Hello Guys, Does anyone know what the part: HOSE,Mfld.to crankcase Cut from 321610 does? It is a hose from the manifold to the crankcase. If it was cracked, would it leak fuel/oil? Any tricks I should consider if I'm going to replace it? I'll have to pull the carb off first to get to it...
  6. J

    Carb retro-fit

    Hey Fellas, Is is possible to retro-fit a 1986 carb on a 1977 outboard? 35 horsepower Johnson. The 1977 carb is no longer available but the '86 is. If it is possible, are there any major stumbling blocks I need to consider? Thanks in advance for your help. -Jeff.
  7. J

    Prop Seal replacement

    Hey Guys, I'm replacing the prop seals on my Johnson 35. The Seloc manual suggests coating the seals with gasket sealer on the outside faces, then grease in between the two seals. Sound right? Thanks-Jeff.
  8. J

    carb adjustment question

    Hey Guys, My carb on my 77 Johnson 35hp was leaking fuel pretty badly. I adjusted the float drop so that only dropped about 1/2". Before, the drop was much lower. Took it out to the lake and the leaking stopped until the end of the day, when it leaked again. It seems like I still haven't...
  9. J

    1977 Johnson 35 hp fuel leak

    Hello Guys, I have a 1977 Johnson 35 with a leaky carb. Engine is 35e77c. I've rebuilt the carb about 3 times following the steps in the carb cleaning page and it still leaks . Replaced needle, seat, gaskets, blown it all out. Turned it over and blew into the fuel inlet to check that the...
  10. J

    throttle cable

    Hello All, I'm replacing my throttle cable. I measured the old one to be 13 feet 4 inches long. They come in 13 and 14 foot lengths. Which one do I need? thanks-Jeff.
  11. J

    Electrical Problem

    Hello Guys, I have a 1977 Johnson 35hp, 35E77C. I took the carb off to clean it and in order to do that I had to disconnect the starter moter from the powerhead to get to the carb bolts. I put the carb back on, put the starter motor back on, turned the key and nothing happened. No clicks, no...
  12. J

    Gasket Sealer and carb question

    Hello Guys, I have a 77 Johnson 35hp 35e77c. Leaks fuel from where the air silencer attaches to the carb. There are two gaskets that sit between the air silencer, air silencer support, and the carb. Is it ok to use gasket sealer on these gaskets? If some gasket sealer got into the fuel mix...
  13. J

    '77 Johnson Throttle Gear Bushing

    Hello All, Anyone know where I can get a new nylon bushing for the throttle gear on my 77 Johnson 35hp? The throttle gear on this engine is usable for both tiller and remote. I have a remote throttle attached. The old bushing is worn out and the gear slips up, causing the cable to come loose...
  14. J

    77 Johnson 35HP oil leak

    could a bad top seal cause oil to leak from right under the armature plate at the top of the powerhead? 77 Johnson 35hp. leaks a lot of oil down from the top of the power head, down the exhaust housing and into the water. Looks like the leak starts right where the powerhead meets the armature...
  15. J

    77 Johnson 35hp water/fuel leak

    It looks like water is leaking from a screw on the top of the powerhead, part number 0315092. The screw is called SCREW, lockout lever boss electric start models. Is it ok to just put gasked sealer on the threads on this part? Anyone seen this before. Thanks-Jeff.
  16. J

    Head Gasket Change?

    I have a 77 Johnson 35HP. After running, I notice oily water running down the exhaust housing and when I remove the engine cover, there is oily water in the bottom of the case. I've checked the carb to see if fuel was leaking from there, but it is ok. I just can't seem to locate the source...
  17. J

    77 Johnson 35HP water pump replacement

    Hello All, I have the new water pump kit to for my Johnson 35. This is my first time to replace one myself. The only way I can get the impeller to fit into the housing is to really twist and force it in there. Is this normal, or did they send me the wrong impeller and/or housing? Thanks-Jeff.
  18. J

    Pre-1984 Johnson Gearcase parts

    have a 77 Johnson 35hp Looks like the clutch dog for the Sierra part 18-1290 has 3 ears as opposed to two. I guess a 3 eared dog won't work with a 2 eared reverse gear? Also looks like that dog requires a different cradle and shift lever. Even if I bought the R,P,F gears from Sierra, I...
  19. J

    1977 Johnson 35HP slipping out of gear

    My engine is making the thump at WOT. It is a 1977 35HP. From the looks of things in my Seloc manual, this looks like an expensive problem. Do they even make replacement gears and clutches for these older engines anymore? Anyone had to deal with a problem like this before? Thanks for your...
  20. J

    '77 Johnson 35HP Fuel Leaks

    Hello engine gurus, Thank you for your help with our boating woes in the world! I still need help, however. My 1977 Johnson 35HP, serial no. 35e77c is leaking fuel down the exhaust housing. I have rebuilt the carb, replacing gaskets, float, inlet needle and seat and blown everything clean...
Top