Search results

  1. R

    Hub and bearing Kit info HELP!!!

    Hi Guys, I need to locate a Hub/bearing Kit for my Homemade Trialer. One of my Hubs Bearings and grease seal were destryed in a towing incedent. No numbers exist on the hub or bearings. What I do Know is this:<br /><br /> It is a 5 hole hub with a 4 1/2 inch bolt pattern<br /> <br /> The...
  2. R

    Using flush fitting for initial startup instead of "rabbit ears"

    Hey Guys, It's the rookie again. I need to know if I can use the flush connection that comes on my 2005 yammy 90hp instead of the normal "rabbit ears" flushing kit. Can I just use the connection on the motor (the female fitting that recieves the water hose). Or do I HAVE to use the rabbit...
  3. R

    battery cable install on 90 yamaha 2 stroke

    Hey guys, I am installing a 90hp 2005 yamaha on my boat and am confused about the diagram in the service manual as to where to hook the battery cables to the motor. Do I hook the posative lead to the starter relay and the negative cable to the starter housing? To put it plainly Where do I...
  4. R

    yammy 90hp 2 stroke 703 throttle/shift cable install

    HEEEELLLLPPPP!!! :) I need help installing throttle/shift cables on my yammy 90hp (2005). I cannot find any instructions online or in the service manual. what are the steps? Do I need adapter kits if I buy teleflex cables. Should I buy Yammy cables? are the premium cables that much...
  5. R

    do I need control cables???

    This May seem like a stupid question, but I need to ask it, so here goes....I just purchased a 2005 90hp yamaha 2 stroke outboard. I also bought new controls (yamaha 703 side mount). The controls I bought has the 9 pin harness on it. DO I still need to purchase control cables for the...
  6. R

    2005 Yamaha 90 hp new installation on my 16'6" Mckee craft

    I am ready to install a new 90hp Yamaha on my 16'6" Mckee craft. I have purchased new 703 throttle controls, new gauges, etc. The 10 pin harness connection will connect right up to my motor, but I have several questions I need help with. 1. I need a diagram for the additional wires coming out...
Top