Search results

  1. F

    Aluminum prop repairs

    Has anyone tried to repair their aluminum props using those rods advertized on TV. I did a search about alumoloy. It sounds like it would work by the comments that are posted. These work using a small torch propane or mapp gas. I'm not looking to repair major damage, just fill in smaller nicks...
  2. F

    Idle adjustment on rochester 2 bl. carb

    My 2.3l omc with pertronix ignition idles at 1200 rpm's out of water. I know I need to be at 600-650 rpm's in gear on the water. Carb has two adjustment screws at the base of it. I have a manual, but I still am a little confused on the adjustments. The boat is a 1988 if it makes a difference...
  3. F

    Installation of transmission cooler

    I am planning on installing a trans cooler which I have not purchased yet. The directions may, or maybe not answer this question. Is it supposed to be hooked up instead of the cooling tube in the radiator, or in addition to it. I was concerned it may keep the fluid to cold in the winters here by...
  4. F

    Towing with a Dodge Caravan 3.3L

    Can anyone tell me if this will work? I have a 17.5 ft. Bayliner, and was wondering if this van could pull it. It is a unibody vehicle, and I'm not sure how to mount a hitch to it.
  5. F

    In or Out of water timing

    What is the proper way to time my engine. I currently set it in the driveway in neutral. Would it not be better to time it in the water, at idle in gear?
  6. F

    2.3 L OHC OMC distributor gear woes

    I have a 1988 OMC 2.3l with aprox.300 hrs run time. My auxiliary shaft gears that drive the distributor gear are gone. Does anybody have an idea why or what would cause this problem. I have flushed out the motor and I'am waiting for the parts to reassemble it. The oil pump turns freely, and...
Top