Search results

  1. J

    Low RPM at WOT 2006 NSF8A3

    Follow up: I contacted TinyTach and was told by a technician the setting should be 360 degrees for my motor. I'll adjust and see where this puts the rpms. I'm assuming that would show higher rpm readings at WOT. This leads me to another question... that would put my idle rpm too high, is it Ok...
  2. J

    Low RPM at WOT 2006 NSF8A3

    Hey folks, hope you can help. I recently purchased a Gheenoe 15'4 (Highsider) that's powered by a Nissan 8 hp 4 stroke (NSF8a3). The stock prop had already been replaced with a Solas 3 blade 8.5x7 aluminum prop before I purchased it. The motor runs great, I haven't had any issues... fires up on...
  3. J

    1999 Nissan NS70C Oil Pump Priming?

    I just replaced the oil filter on my outboard. How do I go about priming the oil pump? I have a service manual and the factory manual and both are vague. Do I add oil to the cup before bleeding the air from the pump or do I just put the filter/cup back on, bleed the air, and then crank it up...
  4. J

    Nissan 70C Problems

    Hello, Took boat out after couple of months sitting. Motor started just like it always does but it seemed like it was running half-speed. Had neutral warm up switch all the way up and motor was running only 2500 (usually ~5000). Then when I let off of the switch to idle motor dies. Thought it...
Top