Search results

  1. E

    1990 evinrude 15

    Does anyone know where to find a wiring drawing on line for this engine. The OMC drawing does not show the wires on the terminal block, netural switch, rectifier. thanks Don
  2. E

    Mercury tilt motor removal

    Can anyone tell me the proper way and what to remove to get at and replace a tilt / trim motor on a 1990 75 HP merc. I was told to remove the hanger brackets and steering tube, is this correct?
  3. E

    1990 75HP Smokes at idle

    My 75Hp Merc smokes a fog bank at idle at higher rpm its fine. It runs smooth at all ranges, what should I look for? The oil injection mark is on the line at idle.
  4. E

    Merc. tilt motor

    How difficult and what do I need to remove to replace the tilt motor on a 1990 75HP merc.
  5. E

    75 HP, smokes a lot at idle

    I have a 1991 75hp merc that runs fine, but at idle it really puts out a lot of smoke, any ideas? The oil injection pump marks are ok.
  6. E

    Cleaning Pontoons

    What is the best way to clean the pontoons on my pontoon boat that is in a fresh water lake?
  7. E

    Smoking at idle

    I have a 91 75hp Merc that smokes bad at idle, at half speed and above it clears up. Does anyone have an idea of a fix?
  8. E

    Merc trim & tilt release

    On my 75 Merc I need to work on the tilt motor, but the manual release screw is all chewed up and I can"t turn it out. Does anyone have any ideas on what I can do to raise the engine or replace the screw.
  9. E

    Lots of smoke

    I have a mid 90s 75HP Merc. ITs runs great, but at idle it smokes so bad. I have to increase the idle in order to clean up the exhust. Is there an adjustment on the oil feed for this?
  10. E

    Service Manual

    Does anyone have a service manual for a 1991 75 HP Merc that I can buy? Where is the best place to go for one?
  11. E

    No tilt problem

    I have a 1991 75 HP Merc. that does not tilt. The soloinds click but no motor. The manual by pass screw is chewed up and won't turn. Can someone help me as to raising the engine to get at the tilt motor? Is the manual screw plastic or is this just a cover pulg?
Top