Search results

  1. J

    coil test

    have 200hp mariner 1996.have alarm going off but it is not heat or oil. when i disconnect spark plug wire from 1,3,5 cylinders the number 1 cylinder does not change. the others act like they are not firing. wondering if could be switch box as the green wire from oil module goes to number one...
  2. J

    switch iisue 200 hp mariner 1996

    have following issue. engine alarm. have replaced oil module,oilsender sensor, oil resovoir sensor, heat sensor. and alrm. the green wire from the oil module goes to post on ignition swith manual hard to read. can anyone tell me if the green wire goes to same post as the green/white wire. i may...
  3. J

    kawaski 900 stx

    loses power after 3500 rpm but not all time. seems to be fuel but does not occur every time. changed to new gasx=, replaced filter. is there another filter and where would it be located any help appreciated. could this be cooling or electric issue thank you in advance for any input
  4. J

    ALARM

    NEED SOME HELP. HAVE ALARM SOUNDING. APPEARS TO BE REALTED TO HEAT SENSOR. I HAVE RELACED THE ALARM ITSELF, THE OIL SENDER FROM THE REOMTE TANK, THE OIL MOTION SENSOR, THE ENTIRE MODULE. THE ONLY TIME THE ALARM STOPS IS IF I DICONNECT THE TAN WIRE WITH THE BLUE STRIPE FROM THE MODULE TO THE POST...
  5. J

    poppett valves

    please describe the location of these valves on 1996 200hp mariner, had kelp in thermostats and am wondering if these valves could be affected a wp is lower than usual. pee hole pour water replaced thermostats
  6. J

    oil warning module

    does anyone have a diagram of the wiring from the oil warning module on 1996 mariner 200. i have the repair manual but cannot read it that well. looking for the place to put the tan wire coming from the module. i believe it goes on post with the wire from the heat sensor. if any diagrams please...
  7. J

    alarm

    any help. have 200 mariner alarm went off a quick beep.replaced oil res cap, oil sensor module,checked oil pump for output. does not seem to be oil issue. if i dissconect tan wire from module to post where it meets heat sensor wire the alarm stops ringing. i have good water flow replaced...
  8. J

    mariner water pump

    was wondering if anyone had attempted installing new water pump while boat was swtill in water since only have to remove lower unit to get to it
Top