Search results

  1. J

    lower unit

    I have a 1988 Johnson 90 hp vro. On the back side of the lower unit there are two small holes, that I believe water is supposed to come out of. One of the holes is about 1 1/2 inches just below the cavation plate, and the other is down near the back side of where the prop shaft comes out. The...
  2. J

    prop

    check with ebay and watch. Go to propellers section, and bid. Good deals but watch the prices. ;) :p
  3. J

    Trim gauge hook up

    I am almost there. The last part I am hooking up is my trim gauge. This is an Omc Part number 174679. What I have on the back of this unit is G=ground,I-ign,and S for sender. The question is there is some sort of resistor across the I and S. I am not sure if the purple wire is supposed to go...
  4. J

    vro wiring hookup

    I have a 1988 Johnson 110 hp model tlcca. This engine has a vro. The person that I purchased the engine,disconnected the two wires from the engine. This vro tank has only two wires coming from the oil reservoir to the engine. One wire has a bullet tip end, and the other end has a closed looped...
  5. J

    WIRING DIAGRAM

    I HAVE A 1988 JOHNSON 110HP MODEL J110TLCC. I AM TRYING TO PUT GAUGES IN MY BOAT AND I CANNOT FIND ANY WIRING DIAGRAMS, ON HOW TO HOOK THEM UP. DO ANY OF YOU KNOW. THANK YOU. :)
Top