Search results

  1. P

    1995 Yamaha Wave Venture Fuel Gauge

    The fuel gauge on my wave venture flashes as if I am on reserve, even when I have a full tank of gas. Any suggestions as to how to fix this problem?
  2. P

    Fuel problems 9 1/2 hp evinrude

    I am working on an older Evinrude 9.5,approx 1970,with the old downdraft carb. The motor runs fine for only a few minutes and then runs out of fuel.If I run the motor and keep the bulb pumped constantly it runs fine,and keeps running. I have change the tanks and hose assembly several times and...
  3. P

    idle problems with 115 Yamaha

    I am working on a 115 twostroke motor that will not idle correctly. C115TLRY The motor appears to have a mind of it's own.When I start it,it will idle at around 850 RPM and then for no reason it will jump to 2000 RPM and then down to 400 RPM. It bounces around for no reason,or at least no...
  4. P

    Link and sync 90 yamaha

    I am working on a 1987 90 hp yamaha 2 stroke. It was missing on the botton 2 cylinders.When I choked both of the cylinders, they would fire. I rebuilt all three carbs and started the motor.It sounds better,but it does not sound right.It kicks every so often and will stall. I checked the...
  5. P

    Suzuki oil leak

    Working on a 9.9 Suzuki oil injected motor.Both the oil fill cap and the oil sender cap leak oil.Both are made of rubber,but both fit fairly loose. They both have several raised rings molded into the rubber as to help seal the cap. When I fill the tank using the fill cap,it ozzes out around...
  6. P

    9.8 timing procedures

    Can anyone help me out with the timing procedure for a 9.8 merc,mid 1970's ? I had a timing light on it and saw were the timing mark at idle was way to the left of the timing window at idle.When I raised the RPM's to half throttle I could get the timing mark almost to the left side of the small...
  7. P

    Cost of rebuild ox225

    Friend has a OX225 on a 24 ft boat.He called me this morning as he was getting towed in. Said the motor had no power and he thinks it "went".This motor is a 1999 and well used but not so well serviced. What would the parts cost for a rebuild,pistons rings bearing etc. Does it make sense to...
  8. P

    Defective hose and bulbs units

    Has anyone else been having problems with "new" fuelline bulbs and setups ? I must have had a 50% defective rate in the new units over the past 6 months.Most will not pump up,some once you squeese it ,it will not expand back so you can squeese it again. Is it just me,or is everyone having the...
  9. P

    1992 48 special UGH.UGH

    I have been working on a 1992 Evinrude that was kind of dropped in my lap to get running.Ugh.It had been sitting for some time and I was asked to mount it on the boat. Mounting the motor was easier than getting it running.Ugh.After rebuilding the two carbs,I did manage to get the motor...
  10. P

    Carb Adjustment 9.8

    I just rebuilt a 9.8 merc using a new kit.I soaked the carb in an untrasonic cleaned and rebuilt it and now I cannot seem to adjust the carb correctly. When I start the motor it does not run well well.I attempted to adjust the carb using the only adjustment screw on the carb.The motor kicks and...
  11. P

    Excessive oil use,reduced RPM,s

    I am working on a OX225 saltwater series Yamaha motor.I had a few issues with the remote oil system and then the oil sending unit in the oil tank on the motor.I got thse problems solved only to discover that the fuel filters and the VST unit filters were in need of replacement,as the motor would...
  12. P

    Wiring Pergo Battery Switch

    I am attempting to wire a dual battery switch (pergo)to two batterys on a boat with two motors.A 150 Yamaha and a 9.9 Yamaha kicker. I read the information provided with the switch and there is no mention of using the switch with two motors. Can anyone tell me if this can be done,and if so ,how...
  13. P

    Remote oil tank questions

    I am working on a 2001 OX225 that had overheated recently. After unseizing the motor I found that the remote oil tank had been run dry and the motor had overheated due to lack of oil,not a water problem as I had been informed. Since I had the boat apart I removed the remote tank and found the...
  14. P

    9.9 evinrude 4 stroke ,carb issues?

    I am working on a 1996 evinrude 4 stroke.It was put away 2 years ago,and this year was started but it did not run right. Thinking the carb was gummed up,I cleaned the carb and attempted to run the motor.The motor will start at idle,but I cannot advance the throttle,at all.When I attempt to...
  15. P

    F9.9 fourstroke carb problems?

    I am working on a 2003 9.9 4-stroke that is having carb issues.This motor is on a boat as a kicker motor to a 115 yamaha.I had to tear down the carbs in the 115 as they were clogged ,dirty,and in some areas coroded.The issues with the 115 solved I turned to the Yamaha kicker motor.Expecting the...
  16. P

    Erratic spark

    I am working on a 115tlrb 2 stroke motor.It has a hard starting problem and will not idle for beans. I decarboned the motor using Powertune and changed the fuel filters etc,and still the problems persist. Using a timing light I checked for consistent spark and was quite surprised when both plugs...
  17. P

    10 hp trigger coil

    Have a 10 hp ,1995 merc with no spark.Using the service manual is pretty basic,but short on information.I am looking for the spec on the CDI box so I can ohm out the unit.CDI box is not in the manual except removing and replacement.Does anyone have the test out procedure? I attempted to test out...
  18. P

    Timing for 140 Evinrude

    Can anyone tell me the correct timing for a 1982 140 Evinrude,and what cylinder is #1. It acts like it is out of time when attempting to start the moter.When spinning the motor over it seems very difficult to spin,almost like it is being restricted somehow.I have not yet tried to start the motor...
  19. P

    12 volt wiring for lights

    I am attempting to install six 12 volt lights in a boat.The bulbs are 12 volt #1156 single filament bulbs.I ran a black wire to all lights and then to the ground side of the master switch wire block.I then ran a white wire to the 6 lights and then put a 30 amp fuse into the line and than I put a...
  20. P

    engine alarms yamaha 9.9

    Yamaha 9.9 fourstroke when the key switch is turned on the alarm sounds a constant tone.When you start the engine the alarn does not turn off.This is a 2 week old motor.The oil light is not blinking and the engine is full of oil.And the water pump is pumping great. Could this be a bad key...
Top