Search results

  1. tdf-texas

    A plumbing problem

    I bet that if you take those four screws out of the bottom of the faucet and remove the bottom plate, you will find O rings / seals that are suppose to seal against the tubing. No glue.
  2. tdf-texas

    MAX HP

    For the rare occasions that you would need the second motor, have you considered a kicker motor? I have a 20hp kicker on my boat that isn't a speed demon but will get me back to the dock.
  3. tdf-texas

    2000 Proline 195 sport with 2000 merc 125 fuel tank question

    From https://www.thehulltruth.com/boating-forum/514150-need-new-fuel-level-sending-unit.html
  4. tdf-texas

    Best technique for waterproof solders?

    Sorry if you misunderstood the post. I do "T" splices on a regular basis as shown in the video - one wire on one side and two on the other. The wires are twisted together, soldered, then covered with a sealed heat shrink. You don't have to make the splice look like a "T", just have the three...
  5. tdf-texas

    Best technique for waterproof solders?

    Twisted, soldered, and heat shrinked with sealant connections last the lifetime of the wire.
  6. tdf-texas

    Strakes on Bunks?

    The bunks are better located under the stringers and/or close to the chines. I bought a Shoreland'r trailer as well and added additional bunks such that the hull was supported under the stringers and the other set of bunks were located at the outside edges of the hull just inside of the chines...
Top