Search results

  1. J

    1996 Force 40 outboard

    Thank you so much.
  2. J

    1996 Force 40 outboard

    When you say static is that with plugs out wide open throttle or leave plugs in and take coil wire off and attach timing light leed to #1 coil. I'm using 87 octane.
  3. J

    1996 Force 40 outboard

    I checked the timing with an induction timing light and time is 9° restarted. I've been trying to set timing at zero at idle and man there are two many adjustment rods on this engine. If I take all adjustment rods looses and get timing set, then adjust rods and throttle linkage to that will that...
  4. J

    1996 Force 40 outboard

    Thank you so much for the information it's greatly appreciated. Will do that you have mentioned and will respond to let you know how it goes. It may take a day or so.
  5. J

    1996 Force 40 outboard

    Thank you. Will give that a try
  6. J

    1996 Force 40 outboard

    Where should the idle air screw be as far as adjustment???
  7. J

    1996 Force 40 outboard

    I did a cylinder drop test a few weeks ago and noticed the engine would run on #1 cylinder alone but not on #2 cylinder alone that's when I put new coils on it. I did put in new reeds too. I have a new filter before the prime bubble and a small white filter before the fuel pump but not one after...
  8. J

    1996 Force 40 outboard

  9. J

    1996 Force 40 outboard

    120 psi on each cylinder
  10. J

    1996 Force 40 outboard

    I just checked the compression and there is 120 psi on each cylinder.
  11. J

    1996 Force 40 outboard

    I have a 1996 force 40 outboard 2 stroke. It has a rough idle. I have rebuilt the carburetor, new plugs , coils, fuel pump and fuel lines with filters. All of these are OE parts. I made sure the throttle plate was horizontal at full throttle. It runs good at 1/4 to 3/4 throttle. At full throttle...
Top