Search results

  1. H

    Wont go past 2500 rpm

    For my boat yes, just make sure your cap and wires are correct it could also be a neutral safety switch or if one of your water temperature switches are going bad you can unplug it and then see if it clears up and if it does replace that sensor
  2. H

    1995 Stratos FS 278 Slow?

    Stratos are set from factory from the boats I’ve owned, I run no jackplate on my 201 pro xl with a 200 and get 72 on glass water, 4 blade 25p
  3. H

    Wont go past 2500 rpm

    Just had a current issue like the with my Johnson after being rebuilt come to find out the wires coming off the power pack was on backwards causing it to idle rev and work in reverse, but soon as I’d go forward it would bog and not go over 2500.
  4. H

    94 Johnson venom 200 Bogging in forward

    Problem is fixed, come to find out the CDI powerpack was going bad replaced it and boom!
  5. H

    94 Johnson venom 200 Bogging in forward

    Car timing fun I seen 4° idle 18° WOT With the new timing gun advance set to 0 TDC idle 12° WOT
  6. H

    94 Johnson venom 200 Bogging in forward

    Well I was under advance timing using a car timing gun I bought a analog timing gun and have advance timing set to 0° on the gun my old timing gun had it 4° off the new gun so it was retarted
  7. H

    94 Johnson venom 200 Bogging in forward

    They are fine just made a reply I believe I found a timing issue but I don’t work in 2 strokes a lot in cars 4° isn’t to much and cause a running issue but is it for a boat motor
  8. H

    94 Johnson venom 200 Bogging in forward

    So I went and bought a new timing light for the giggles, at idle I was TDC vs 4° and wot I was 12° vs 18°, I have it dialed in to 4° on muffs but haven’t put it in the water yet could this been my issue from the get go
  9. H

    94 Johnson venom 200 Bogging in forward

    As far as I can tell yes, I’m fixing to put a new timer base on and cdi panel and reset timing
  10. H

    94 Johnson venom 200 Bogging in forward

    That’s the switch on the actual linkage that clips in correct
  11. H

    94 Johnson venom 200 Bogging in forward

    Yes
  12. H

    94 Johnson venom 200 Bogging in forward

    Also I did change stators, only thing different from the old powerhead, what if the stator I’m using isn’t sending enough power to the cdi could that be an issue, I honed out the triggers with it off and both read pretty close 76ohm and the old stator did as well
  13. H

    94 Johnson venom 200 Bogging in forward

    Did a sync link prior to setting time and idles fantastic, just soon as I put it in gear to go forward and give it gas it just bogs. It don’t spit and sputter just bogs
  14. H

    94 Johnson venom 200 Bogging in forward

    Oms is bypassed and that will be my next thing to check but as far as I know my fuel system is solid as far as pressure goes I just put a new fuel filter on it again and I am headed to go test what I’ve done
  15. H

    94 Johnson venom 200 Bogging in forward

    Could the rectifier being bad cause this issue I have one on the way
  16. H

    94 Johnson venom 200 Bogging in forward

    So yes, the wires are going to the correct run of coil packs, I have unplugged, a spark, plug wire off of each plug and tested and yes, you can hear the misfire with each coil pack becoming unplugged. The fly key is in place and the flow is locked down so I know that is not an issue, when the...
  17. H

    94 Johnson venom 200 Bogging in forward

    So I recently had my powerhead rebuilt due to the block, locking up and replaced the whole powerhead assembly, I had the carbs rebuilt along with new fuel, lines, prime, and bulb spark, plugs, power pack and new stator put on because I assumed the old one was going bad but after both of them...
Top