Search results

  1. B

    I need help

    It was inside the main wiring harness plug . Rusted from moisture and not broken after all, just cleaned up and dielectric grease and zipped tied it for a tighter fit. Seems like it was bouncing around and cutting out.
  2. B

    I need help

    Thanks for all that replied. The problem was a broken connector, bouncing around and loosing connection. So electrical was the problem. Thanks again
  3. B

    I need help

    ok, i will run a couple of test's and see what happens, thanks for the input.
  4. B

    I need help

    Sorry missed the tks question, not sure what that is. Just a diy guy, trying to solve the problem. The dealership near me had it and returned it with the same problem after installing the plugs wires and cap and rotor. Can't count on them. They said they had it running and it ran fine then i...
  5. B

    I need help

    Carb
  6. B

    I need help

    I have a 99 4.3 mercruiser . The boat will idle, throttle , and run fine until.... . When it gets about 165-170 temp on the gauge, the motor shuts off like someone pulled the key. If i wait for it to cool off, i can start it up and get it back to shore, if I'm close enough. If it gets back to...
Top