Search results

  1. M

    1957 35hp johnson

    Can I adjust the jets without taking the carb off the motor?
  2. M

    1957 35hp johnson

    Is this the nut I would loosen to adjust the needles for low and high lean/rich? They are in front of the air intake box and behind the front cover plate.
  3. M

    1957 35hp johnson

    Oh ok. It only has pull start. I'll have to disconnect the pressure relief and see what results I get.
  4. M

    1957 35hp johnson

    Yes has good spark. I'm thinking it mite be a fuel problem. Found out motor Has been sitting since 2018. Has 90 psi compression on both cylinders.
  5. M

    1957 35hp johnson

    I replaced the points and condensers. I checked the coils and they were good. I tested spark after I put it back together. Has nice strong spark on both cylinders. Fuel tank is good also.
  6. M

    1957 35hp johnson

    Yes pressure tank is good. Cap seals when closed, the primer in it works and also builds pressure when motor is running. The oiler wick is in place on cam.
  7. M

    1957 35hp johnson

    I changed points in my motor. It has great spark. Took boat to the lake. It started on 2nd pull and ran about 10 seconds then died. It wouldn't even sputter after that. Before I changed the points it was very cold blooded. When I did get it to run it ran great then suddenly died. That's when I...
  8. M

    1950s Alumacraft boat

    Ok great thanks. I took a pic of the brace with numbers and sent it to Alumacraft.
  9. M

    1950s Alumacraft boat

    Hello, I have a 1950s 16ft 56 inches wide Alumacraft boat. It has the removable aluminum cover in the front about 36 inches. It didn't have a title when I bought it, so when I got a title it says 2011. I don't see any factory numbers on it. There is an alumacraft tag on front seat that says...
Top