Search results

  1. D

    I turn the key but nothing happens.

    I have not just because I figured it was fine since it was relatively new but I will do that.
  2. D

    I turn the key but nothing happens.

    I should also mention that when I was installing my new transducer wire that pulling it through was hard so I had to yank a couple times. Could this have disconnected any wires?
  3. D

    I turn the key but nothing happens.

    Yes I did. I was greasing the parts inside and I’m wondering if I bumped the shifter cable to not neutral.
  4. D

    I turn the key but nothing happens.

    There is only a click when I put the key in to activate the choke. Otherwise nothing
  5. D

    I turn the key but nothing happens.

    I will take it apart after work tonight and take a look!
  6. D

    I turn the key but nothing happens.

    I took it apart to grease cables and no I did not have any left over parts. I was messing with the parts inside to try and get more grease into them so I wonder if I bumped the shifter one too much.
  7. D

    I turn the key but nothing happens.

    I’ve looked into the kill switch and it appears to be in the run position. I’ve also tried rocking the throttle while holding the key in the start position.
  8. D

    I turn the key but nothing happens.

    Hello all, Recently I did some work on my boat. That included greasing my shift and throttle cables on my Mercury 3000 controller. I don’t know if this is related but after I was all done, I would turn the key and nothing would happen. Every light and all of the electronics work but the motor...
Top