Search results

  1. T

    Bent Lower Shift Shaft

    Did a pressure test on the lower unit. Needed a new shift shaft seal. Installed a new one and still showed a leak out of the shift shaft seal with soapy water. Pulled the shift shaft out to take a closer look and noticed it was bent at the spot where the shaft goes into the seal. I’m assuming...
  2. T

    Bayliner Blank Gauge Cluster?

    Tried there already. No luck 😕
  3. T

    Bayliner Blank Gauge Cluster?

    I have a 2006 Bayliner 185 Bowrider and I have some crack in the gauge cluster. I have looke all over the internet and cannot find a new, or used blank gauge cluster. Anyone have any ideas where else I can look or ideas….? The pic is what it looks like.
  4. T

    What Bearing Puller?

    Seriously? How well does that work? That would be a millions times easier
  5. T

    What Bearing Puller?

    Trying to replace the top cover bearing cup on the upper drive shaft after replacing the seals. The race has some pits in it. In the manual I only see the parts number for the puller rod? I can’t seem to find any pullers that will fit so I can actually pull the bearing cup out. What did you guys...
  6. T

    Soak Bearings in Rust Remover?

    Yea, not sure if it’s an illusion or what, but I noticed that on the previous post when someone mentioned it and went back and looked over the gears probably at least 5 times. I don’t see any chip at all on either side and the top 🤷🏻‍♂️
  7. T

    Soak Bearings in Rust Remover?

    I’ve ordered a new upper bearing and cup and will replace
  8. T

    Soak Bearings in Rust Remover?

    Well glad I reached out to you guys. The spin freely and looking closer now, not sure if it’s rust or what. Tried using 600 grit sandpiper and it does remove some of it, but not all. Does those pics look like rust? Kinda leaning towards replacing it. It was just that upper bearing and race. I...
  9. T

    Soak Bearings in Rust Remover?

    Yes that’s it. Here are some pics.
  10. T

    Soak Bearings in Rust Remover?

    Replaced the oils seals in my alpha one gen 2 upper drive shaft. Everything looks good. However, my upper driven gear assembly looks like it has some light rust on it. Nothing that worries me. But I was thinking about submerging it in some WD40 rust remover, clean it off really well and re lube...
Top