Search results

  1. R

    Water pump impeller

    I know this is a stupid question but please bear with me. When you install a water pump impeller, what happens if you turn the rubber impeller fins the wrong way? Will they right themself? The reason I am asking is I put a new water pump kit on my 1990 Evinrude 200 while i was preparing to put...
  2. R

    Initial screw adjustments 2000 135hp

    The throttle body of my 2000 135 johnson has 4 adjustment needles. when cleaning the carbs each one of these screws was out from 4 to 5 1/2 turns. what should be the initial turns out from being seated to start fine tuning them. what do I "look"? for as far as running quality adjusting these...
  3. R

    Idle Timing for 1999 135hp

    Con someone tell me what the idle timing should be for a 1999 Johnson 135? What should the wot timing be also? I have the sync and linc procedure but my manual does not say what the Idle and wot timings should be. I think the idle should be 8 deg atdc +/-1 deg and the wot 18 deg +/-1 deg is this...
  4. R

    Adding a water separator to Johnson 135

    Hi all, I am adding a water separator to my 2001 Johnson 135 and need to know if I should put the fuel primer bulb between the tank and the separator or the separator and the motor? Any recommendations? Thanks in advance
  5. R

    Water Pump on Johnson 90hp

    In going to replace the water pump on my Johnson 90. I dont know what year model it is though to order the pump. The model no is J90TLC05 and the serial is J6145363. It has a vro but I dont use it and just premix. Can anyone tell me what year model this motor is? Does it have the waterpump...
  6. R

    1980 135hp V4 Evinrude

    I have a 1980 135 HP V4 Evinrude and want to do a water pump job and all the bolts are out but the lower unit wont drop I have the 4 bolts out, the one under the trim tab, and the shift rod is disconnected so I think the drive shaft spline is rusted to the crank. This motor has had allot of salt...
  7. R

    1990 RUDE XP200

    Posted with a cutting out problem on my 1990 XP200 a couple of weeks ago (post name L77VJC4 vs QL77VJC4) and I was told to replace L77VJC4 w/QL77JC4's going to give it a try this weekend. What should I set the gap for? I premix 50:1 (vro unhooked)
  8. R

    QL77V vs Ll77V

    I have a 1990 Evinrude XP200 and use L77V-jc4 plugs and gap them at .35 what is the diffrence between L77V-jc4 and QL77V-jc4? Is ther anything wrong with running the L77V's? Also after my first outing this year I started having a problem- above 4000 rpm the motor will drop out just like a no...
Top