Search results

  1. R

    Lower unit seals, how to get them out.

    Still working on the 1979 15 HP attempting to install new seals on the lower unit behind the prop. I took the prop off, removed the two bolts on the housing but cannot get the housing to come out. Is there somthing else holding it besides the two bolts I took out? Do not want to put too much...
  2. R

    15 HP Evinrude still missing after tune up

    1979 15 HP model # 15954E Completed tune up new coil paks, plugs, carb. kit, took flywheel off and cleaned contacts and a new fuel pump. It runs better but I still have a miss that I cannot locate. All of the parts under the hood except for the ones I just listed are the originals form 79. I...
  3. R

    Where do I find parts in Dallas?

    I need a fuel pump assembly for a 1979 15 HP outboard Evinrude model# 15954E I could order it and have it shipped but would like to pick up the part and install on Monday. Anyone know who would most likely have a part like this over the counter in the Dallas metroplex? I have two part numbers...
  4. R

    Max RPMs

    Performing a tune up and cannot find the Max RPMs for this little engine. Anyone know? 1979 15HP outboard Evinrude Model # 15954E Thanks
  5. R

    Fuel filter question

    1979 15 HP Evinrude Just installed a carb. kit (dirtest carb. I have ever seen on an engine that was still running) noticed there is no fuel filter, I installed a inline filter. Did they produce these with no filter or did somone maybe remove it and never put it back? Just curious. Never...
  6. R

    Torque spec, Flywheel nut

    1979 15 HP Evinrude model # 15954E Had to take flywheel off to remove starter for rebuild, what is the torque spec for the flywheel nut?
  7. R

    Ignition Coil question

    1979 Evinrude 15HP, Has the original coils on it was going to include replacing with the tune up. The smaller wire from the old coil goes into a rubber block that I cannot get the wire out of so is it okay to cut the old wire from the rubber block and connect the new wire to it with a solderless...
Top